Well water in Brookline, New Hampshire

1in12

Testing recommended

private wells tested between 2006 and 2020 in Brookline had uranium above the New Hampshire guidance level (30 ug/L), according to NH DHHS.

163 private wells tested 2006 to 2020 in state summaries; 45 test results across 12 contaminants from at least 7 wells, 1964 to 2012; manganese has the most at 7. Data refreshed September 3, 2026.

Compiled by Nick at Well Water Nerd from public records. How these pages are built

Separately, a USGS and NHDES statistical model puts the chance that a bedrock well in Brookline exceeds 5 ug/L of arsenic at 3% (as low as 1% in parts of town), based on geology rather than tests.

What homeowner tests found

NH DHHS WISDOM private well summaries: private wells tested and reported to the state, 2006 to 2020. Shares are against the level the state applies to each contaminant, named in the last column; several are stricter than EPA.

Contaminant	Above state level	Wells tested	Median	95th pct	Highest	State level
Sodium	29%	34	11.4	90.8	103	20 mg/L
Uranium	8%	36	6.6	37.5	58	30 ug/L
Lead (stagnant)	7%	27	1.7	14.5	17.3	15 ug/L
Copper (stagnant)	7%	27	0.2	2.6	4	1.3 mg/L
Iron	6%	34	0	300	4,600	300 ug/L
Arsenic	3%	38	0.7	0.8	18.4	5 ug/L
Fluoride	<1%	163	0.1	1.7	5	4 mg/L
Chloride	0%	50	5.8	88.3	130	250 mg/L
Nitrate	0%	45	0.1	2.1	3.2	10 mg/L
Nitrite	0%	45	0	0	0.1	1 mg/L
Manganese	0%	34	0	100	300	300 ug/L

Closer than the town

See the sampled wells near your address

The same records, drawn around one point: which wells within a few miles were sampled and what they found, how deep the wells next to you were drilled, and any leaking tank or cleanup site within a mile.

Check my address

What this means

Among homeowners in Brookline who sent a sample to the state lab, the health-based limits most often exceeded were uranium (8% of 36 wells), lead (7% of 27 wells), and copper (7% of 27 wells). These are ordinary wells tested by their owners, so the shares are the best available picture of a typical well here, with one caveat: people test more often when they suspect a problem.

Sodium exceeds the state's advisory level in a sizable share of wells; this is mostly a taste, staining or diet issue rather than a toxicity one.

What to test for in Brookline

1
Uranium
8% of 36 local wells tested were above the New Hampshire guidance level.
2
Lead
7% of 27 local wells tested were above the New Hampshire guidance level.
3
Copper
7% of 27 local wells tested were above the New Hampshire guidance level.
4
Arsenic
3% of 38 local wells tested were above the New Hampshire guidance level.
5
Fluoride
<1% of 163 local wells tested were above the New Hampshire guidance level.
6
Coliform bacteria
Recommended for every private well, every year.
7
Radon
Median local reading is 1,890 pCi/L.
8
Sodium
29% of 34 local wells tested were above the New Hampshire guidance level.
9
Volatile organic compounds (VOCs)
1 leaking underground storage tank site on record locally.
10
PFAS
1 unlined landfill on record locally.
11
Metals panel
1 hazardous waste site on record locally.

Test your Brookline well for uranium, lead and copper

Certified lab analysis of your own tap water, bottles and prepaid return shipping included. The Essential well panel covers arsenic, uranium, nitrate, lead, copper, manganese, iron, sodium and bacteria; radon and PFAS are add-ons.

Order the Tap Score well water test kit, from $209 Already tested? Upload the report

Just want bacteria checked first? Tap Score coliform and E. coli test, $99. Coliform and E. coli are the tests every well needs every year.

Want a quick look before paying for a lab? Home well water test strips on Amazon check hardness, iron, pH and nitrate in minutes. They are a screen, not a result: arsenic, bacteria, uranium and PFAS need a certified lab.

Affiliate links: the merchant pays us a commission and the price is the same for you. It does not change what the data above says. As an Amazon Associate we earn from qualifying purchases.

Where to get a well tested in New Hampshire: certified labs, state programs and prices.

Already have results back? Get your lab report read against the Brookline numbers, $29. Every line explained, ranked by what matters, with the fix for each.

Wells in Brookline

1,265 domestic wells in Brookline are on record with the state since 1984. 98% are drilled into bedrock, and the typical well is 420 feet deep (one in ten goes past 1,000 feet).

In a typical Brookline well, bedrock starts about 14 feet down, the median yield is 8 gallons per minute, 17% of wells yield under 3 gallons per minute and usually need a storage tank.

Bedrock wells are where arsenic, uranium and radon come from: the water sits in fractures in granite and metamorphic rock and picks up whatever the rock carries. That is why testing for those three matters more here than in a dug or gravel well.

183

1980s

446

1990s

286

2000s

219

2010s

130

2020s

Find your own well's report

The state keeps the driller's report for most wells drilled since 1984. It tells you how deep your well is, where bedrock starts, and how much water it makes, which decides what treatment can work.

Open NHDES OneStop and choose Water Well.
Enter your town and one word of your street name. Leave out the house number and the Road or Street part; a short search matches more.
In the results, click Show for your address to see the report: total depth, depth to bedrock, casing, yield in gallons per minute, static water level, and the driller.
Save Results exports the whole list to a spreadsheet.

Reports exist only for wells drilled since January 1984, when reporting became mandatory, and street names are as they were when the well was drilled.

The rock under Brookline

Not a principal aquifer

The USGS map places this area outside any principal aquifer, which usually means wells here draw from fractured bedrock or thin local deposits rather than a large regional aquifer. Bedrock wells of that kind are where arsenic, radon and uranium turn up, and yields vary from well to well.

Classification from the USGS Principal Aquifers of the United States (national map, 2003 edition, GIS release 2015), read at the town centroid. A single well can sit in a different unit, especially near a boundary.

Official help in New Hampshire

Two places to start that are not selling anything: the state program that answers private well questions, and its list of labs certified to run drinking water tests. A certified lab is the difference between a result you can act on and a number.

Private Wells, NHDES
New Hampshire Environmental Laboratory Accreditation Program, NHDES

Contamination sources on record in Brookline

NHDES records 1 leaking underground storage tank site, 1 unlined landfill, 1 hazardous waste site, and 5 reported spills and releases in Brookline, among 41 regulated sites in total. Groundwater does not follow property lines, so a well within a few hundred feet of one of these is worth testing for what that site could release.

1: leaking underground storage tank siteGasoline and heating oil that leaked from tanks move through groundwater as benzene, MTBE and other volatile organic compounds.
1: unlined landfillOlder unlined landfills are a leading source of PFAS, VOCs and metals in nearby wells.
1: hazardous waste siteSolvents, degreasers and metals from industrial sites can travel far in fractured bedrock.
5: reported spills and releasesMost spills are fuel; a few are solvents or chemicals that reach the water table.
5: registered underground storage tank sitesRegistered tanks are regulated and inspected; they matter most when they are old or near a shallow well.
4: locally identified potential contamination sourcesTowns inventory these (vehicle repair, labs, salt piles, farms) when they draw wellhead protection maps.
23: other remediation projects
1: other solid waste facility

Treatment that fits the local profile

Uranium

Point-of-use reverse osmosis; Anion exchange; Whole-house anion exchange

Lead

Point-of-use reverse osmosis; Certified lead-removal carbon filter; Neutralizing filter to raise pH and stop leaching

Copper

Neutralizing filter to raise pH; Point-of-use reverse osmosis

Sodium

Point-of-use reverse osmosis; Distillation

Iron

Oxidizing filter whole-house; Water softener (low levels); Aeration plus filtration

Manganese

Oxidizing filter (greensand, birm) whole-house; Water softener (low levels); Point-of-use reverse osmosis

Systems we would look at first

Some links below are affiliate links. If you buy through one, the merchant pays us a commission at no extra cost to you. It does not change which products we list or what the data says.

For uranium

Under-sink reverse osmosis system

under-sink or countertop, about $300

Look for NSF/ANSI 58 certification listing the contaminant you need removed.

For uranium

Whole-house arsenic and uranium filter

whole-house, at the point of entry, about $2,500

Adsorptive iron-based media; sized to your well yield.

For lead

Aquasana SmartFlow reverse osmosis

under-sink or countertop, about $225

Certified to NSF/ANSI 58 and 53 to reduce arsenic (96%, pentavalent), fluoride (90%), lead (99%), nitrate, nitrite and PFOA/PFOS at the kitchen tap, with a remineralizer.

For lead

Acid neutralizing filter

whole-house, at the point of entry, about $1,200

Raises pH so plumbing stops leaching lead and copper.

For lead

Aquasana Claryum 3-Stage under-sink filter

under-sink or countertop, about $175

Certified to NSF/ANSI 53 to reduce 99% of lead and 99.7% of PFOA and PFOS at the tap. Not a fix for arsenic, nitrate or bacteria.

For iron

Iron and manganese oxidizing filter

whole-house, at the point of entry, about $1,800

Air-injection or greensand media; fixes staining at the source.

Free, no obligation

Get on the list for a free in-home water test in Brookline

No water treatment company serves Brookline through Well Water Nerd yet. We are signing licensed companies on county by county: they test at your tap for free, walk you through the numbers, and quote treatment only if something needs fixing. Leave your details and you are first in line. Nothing is shared until a company joins for Brookline, and you get an email naming it first.

Common questions

How deep are wells in Brookline?

The typical domestic well in Brookline is 420 feet deep, based on 1,265 wells reported to the state since 1984. One in ten is deeper than 1,000 feet. 98% are drilled into bedrock.

How often should I test a private well in Brookline?

Test for bacteria and nitrate every year. Test once for arsenic, uranium, radon, fluoride, manganese and PFAS, then again every three to five years or after any change in taste, color, or plumbing.

Towns near Brookline

Closest first. Groundwater does not stop at a line on a map, so the next town over is a fair second opinion.

Want the numbers themselves? Download the New Hampshire dataset as CSV, every county and town, with the sources named.

Sources

USGS Water Quality Portal: 45 samples in Brookline. Data from the Water Quality Portal, a service of USGS, EPA and USDA; groundwater samples collected by USGS and cooperators. Retrieved September 3, 2026.
NH DHHS WISDOM private well summaries: summaries for 11 contaminants in Brookline, up to 163 wells each. Town summaries of private well tests run by the New Hampshire Public Health Laboratories, published by NH DHHS through the WISDOM environmental public health tracking portal. Exceedance shares use New Hampshire guidance levels, which are stricter than EPA for arsenic (5 ug/L), manganese (0.3 mg/L), radon (2,000 pCi/L) and sodium (20 mg/L). Statistics for small counts are suppressed (*). Retrieved September 3, 2026.
NH DHHS WISDOM private well summaries: modeled chance (3%) that a well in Brookline exceeds 5 ug/L of arsenic, from geology rather than tests. Town summaries of private well tests run by the New Hampshire Public Health Laboratories, published by NH DHHS through the WISDOM environmental public health tracking portal. Retrieved September 3, 2026.
NHDES Water Well Inventory: 1,314 well records in Brookline, 1,265 domestic. Well construction records reported to the New Hampshire Department of Environmental Services Water Well Board. Only aggregates are shown; owner names and addresses are never stored. Retrieved September 3, 2026.
NHDES OneStop regulated sites: 41 regulated sites located in Brookline. Remediation sites, underground storage tanks, solid waste facilities and potential contamination sources from the New Hampshire Department of Environmental Services OneStop database. Retrieved September 3, 2026.

Non-detects count as samples and are treated as zero when computing medians. Exactly at the limit counts as not above it. A sample belongs to the town containing the well's reported coordinates.