Well Water Nerd

Well water in Lincoln County, Missouri

1in5

Testing strongly recommended

private wells tested between 2010 and 2023 in Lincoln County had fluoride above the EPA limit (4 mg/L), according to Missouri DHSS.

114 private wells tested 2010 to 2023 in state summaries; 69 test results across 8 contaminants from at least 16 wells, 1941 to 1991; chloride has the most at 16. Data refreshed September 15, 2026.

Compiled by Nick at Well Water Nerd from public records. How these pages are built

Missouri does not require private well testing, so these are samples homeowners chose to send to the state lab, often after a problem; shares above the limit run higher than a random survey would find.

An estimated 22,726 people in Lincoln County get their drinking water from a private well, per USGS 2015 county water use. That is about 42% of residents.

Separately, the USGS national arsenic model estimates that 2% of the 22,726 people on private wells in Lincoln County draw water above 10 ug/L (the model's range is 2% to 3%), from geology and well depth rather than local tests.

What homeowner tests found

Missouri DHSS private well sampling summaries: private wells tested and reported to the state, 2010 to 2023. Shares are against the level the state applies to each contaminant, named in the last column; several are stricter than EPA.

ContaminantAbove state levelWells testedMedian95th pctHighestState level
Fluoride1004 mg/L
Iron104300 ug/L
Chloride104250 mg/L
Nitrate11410 mg/L
Lead11215 ug/L
Uranium5730 ug/L
Arsenic5710 ug/L

What individual samples found

Each row summarizes every public sample for that contaminant inside Lincoln County. Above limit means above the EPA maximum contaminant level; where EPA has no enforceable limit, the row shows a health guideline or nuisance level instead.

ContaminantAbove limitSamplesDetectedMedianHighestLimit
Nitrate
1956 to 1991
1587%00.90410 mg/L
EPA limit
Fluoride
1960 to 1971
11100%0.92.34 mg/L
EPA limit
Chloride
1941 to 1971
no limit16100%54846250 mg/L
nuisance level
Iron
1956 to 1971
no limit11100%3008,000300 ug/L
nuisance level

Sampled fewer than 10 times, too few to summarize: Copper (1), Lead (1), Manganese (7), Sodium (7).

Closer than the county

See the sampled wells near your address

The same records, drawn around one point: which wells within a few miles were sampled and what they found, how deep the wells next to you were drilled, and any leaking tank or cleanup site within a mile.

Check my address

What this means

Among homeowners in Lincoln County who sent a sample to the state lab, the health-based limits most often exceeded were fluoride (21% of 100 wells) and nitrate (<1% of 114 wells). These are ordinary wells tested by their owners, so the shares are the best available picture of a typical well here, with one caveat: people test more often when they suspect a problem.

Iron exceeds the state's advisory level in a sizable share of wells; this is mostly a taste, staining or diet issue rather than a toxicity one.

What to test for in Lincoln County

  1. 1
    Fluoride
    21% of 100 local wells tested were above the EPA limit.
  2. 2
    Nitrate
    <1% of 114 local wells tested were above the EPA limit.
  3. 3
    Coliform bacteria
    Recommended for every private well, every year.
  4. 4
    Iron
    11% of 104 local wells tested were above the EPA secondary standard.
  5. 5
    Chloride
    6% of 104 local wells tested were above the EPA secondary standard.
  6. 6
    Copper
    Detected in 100% of local samples.
  7. 7
    Manganese
    Detected in 100% of local samples.
  8. 8
    Volatile organic compounds (VOCs)
    5 hazardous waste sites on record locally.
  9. 9
    Metals panel
    5 hazardous waste sites on record locally.

Test your Lincoln County well for fluoride, nitrate and coliform bacteria

Certified lab analysis of your own tap water, bottles and prepaid return shipping included. The Essential well panel covers arsenic, uranium, nitrate, lead, copper, manganese, iron, sodium and bacteria; radon and PFAS are add-ons.

Order the Tap Score well water test kit, from $209Already tested? Upload the report

Just want bacteria checked first? Tap Score coliform and E. coli test, $99. Coliform and E. coli are the tests every well needs every year.

Want a quick look before paying for a lab? Home well water test strips on Amazon check hardness, iron, pH and nitrate in minutes. They are a screen, not a result: arsenic, bacteria, uranium and PFAS need a certified lab.

Affiliate links: the merchant pays us a commission and the price is the same for you. It does not change what the data above says. As an Amazon Associate we earn from qualifying purchases.

Where to get a well tested in Missouri: certified labs, state programs and prices.

Already have results back? Get your lab report read against the Lincoln County numbers, $29. Every line explained, ranked by what matters, with the fix for each.

Wells in Lincoln County

3,268 domestic wells in Lincoln County are on record with the state since 1987. the typical well is 517 feet deep (one in ten goes past 680 feet).

In a typical Lincoln County well, the median yield is 42 gallons per minute.

206
1980s
912
1990s
1,181
2000s
646
2010s
312
2020s

Find your own well's report

The state keeps the driller's report for most wells drilled since 1984. It tells you how deep your well is, where bedrock starts, and how much water it makes, which decides what treatment can work.

  1. Open Missouri DNR WIMS and choose Water Well.
  2. The certification record lists total depth, casing length, static water level, yield and the driller.

Missouri has required certification of new private wells since 1987, so a well drilled before then usually has no record.

The rock under Lincoln County

Not a principal aquifer

The USGS map places this area outside any principal aquifer, which usually means wells here draw from fractured bedrock or thin local deposits rather than a large regional aquifer. Bedrock wells of that kind are where arsenic, radon and uranium turn up, and yields vary from well to well.

Classification from the USGS Principal Aquifers of the United States (national map, 2003 edition, GIS release 2015), read at the county centroid. A single well can sit in a different unit, especially near a boundary.

Official help in Missouri

Two places to start that are not selling anything: the state program that answers private well questions, and its list of labs certified to run drinking water tests. A certified lab is the difference between a result you can act on and a number.

Contamination sources on record in Lincoln County

Missouri DNR records 5 hazardous waste sites in Lincoln County, among 25 regulated sites in total. Groundwater does not follow property lines, so a well within a few hundred feet of one of these is worth testing for what that site could release.

5
hazardous waste sitesSolvents, degreasers and metals from industrial sites can travel far in fractured bedrock.
19
registered underground storage tank sitesRegistered tanks are regulated and inspected; they matter most when they are old or near a shallow well.
1
other solid waste facility

Treatment that fits the local profile

Fluoride

Point-of-use reverse osmosis; Activated alumina; Distillation

Iron

Oxidizing filter whole-house; Water softener (low levels); Aeration plus filtration

Chloride

Point-of-use reverse osmosis; Distillation

Manganese

Oxidizing filter (greensand, birm) whole-house; Water softener (low levels); Point-of-use reverse osmosis

Systems we would look at first

Some links below are affiliate links. If you buy through one, the merchant pays us a commission at no extra cost to you. It does not change which products we list or what the data says.

For fluoride

Under-sink reverse osmosis system

under-sink or countertop, about $300

Look for NSF/ANSI 58 certification listing the contaminant you need removed.

For fluoride

Aquasana SmartFlow reverse osmosis

under-sink or countertop, about $225

Certified to NSF/ANSI 58 and 53 to reduce arsenic (96%, pentavalent), fluoride (90%), lead (99%), nitrate, nitrite and PFOA/PFOS at the kitchen tap, with a remineralizer.

For iron

Iron and manganese oxidizing filter

whole-house, at the point of entry, about $1,800

Air-injection or greensand media; fixes staining at the source.

Free, no obligation

Get on the list for a free in-home water test in Lincoln County

No water treatment company serves Lincoln County through Well Water Nerd yet. We are signing licensed companies on county by county: they test at your tap for free, walk you through the numbers, and quote treatment only if something needs fixing. Leave your details and you are first in line. Nothing is shared until a company joins for Lincoln County, and you get an email naming it first.

What are you worried about?

The test is free and there is no obligation. No company is named yet; your details stay with us until one joins for your area, and we log the time and address of this request.

Common questions

How deep are wells in Lincoln County?

The typical domestic well in Lincoln County is 517 feet deep, based on 3,268 wells reported to the state since 1987. One in ten is deeper than 680 feet.

How often should I test a private well in Lincoln County?

Test for bacteria and nitrate every year. Test once for arsenic, uranium, radon, fluoride, manganese and PFAS, then again every three to five years or after any change in taste, color, or plumbing.

Counties near Lincoln County

Closest first. Groundwater does not stop at a line on a map, so the next county over is a fair second opinion.

Want the numbers themselves? Download the Missouri dataset as CSV, every county and town, with the sources named.

Sources

  • USGS Water Quality Portal: 69 samples in Lincoln County. Data from the Water Quality Portal, a service of USGS, EPA and USDA; groundwater samples collected by USGS and cooperators. Retrieved September 3, 2026.
  • Missouri DHSS private well sampling summaries: summaries for 7 contaminants in Lincoln County, up to 114 wells each. County summaries of private well samples analyzed by the Missouri State Public Health Laboratory, 2010 to 2023, published by the Missouri Department of Health and Senior Services. Counts are samples, not distinct wells. Shares are against the EPA maximum contaminant level, or the EPA secondary standard for chloride and iron. Counties with fewer than 20 samples are flagged unreliable by DHSS and are kept here with their counts so the threshold rule can judge them. Barium, sulfate and zinc layers exist but have no contaminant page yet. Retrieved September 15, 2026.
  • USGS national arsenic model (Ayotte 2017): estimated share of 22,726 people on private wells in Lincoln County above 10 ug/L of arsenic, from geology, well depth and land use. County estimates of domestic well users with arsenic above 10 ug/L from the USGS national logistic regression model (Ayotte, Medalie and Qi, 2017), with private well population from the USGS 2015 county water-use compilation (Dieter and others, 2018). Retrieved September 15, 2026.
  • Missouri DNR certified well records: 4,227 well records in Lincoln County, 3,268 domestic. Well certification records from the Missouri Department of Natural Resources Wellhead Information Management System (WIMS), published through MSDIS. Only aggregates are shown; owner names and addresses are never stored. Retrieved September 15, 2026.
  • Missouri DNR regulated sites: 25 regulated sites located in Lincoln County. Permitted solid waste facilities, and leaking tank, underground tank and hazardous waste sites from the historical CARES potential contaminant site inventory, Missouri Department of Natural Resources. Retrieved September 15, 2026.

Non-detects count as samples and are treated as zero when computing medians. Exactly at the limit counts as not above it. A sample belongs to the town containing the well's reported coordinates.