Well Water Nerd

Well water in Crawford County, Ohio

No public well test results have been compiled for Crawford County yet. The USGS national arsenic model estimates that 23% of the 14,014 people on private wells there draw water with arsenic above 10 ug/L, the EPA limit, based on geology, well depth and land use rather than local tests.

The strongest signal is coliform bacteria: Recommended for every private well, every year, too few samples to carry the headline but first on the test list below.

22 test results across 10 contaminants from at least 3 wells, 1991 to 2016; nitrate has the most at 8. Data refreshed September 15, 2026.

Compiled by Nick at Well Water Nerd from public records. How these pages are built

Data confidence: estimate. No state program or federal monitoring data for Crawford County has been compiled here yet, so the arsenic figure is the USGS national model, not a measurement. Treat a high estimate as a reason to test, not as your well's number. Measured results are added as states publish them.

An estimated 14,014 people in Crawford County get their drinking water from a private well, per USGS 2015 county water use. That is about 33% of residents.

Closer than the county

See the sampled wells near your address

The same records, drawn around one point: which wells within a few miles were sampled and what they found, how deep the wells next to you were drilled, and any leaking tank or cleanup site within a mile.

Check my address

What this means

Among contaminants with a federal limit, no tested sample in Crawford County came back above it. That is reassuring, but sampling is uneven: wells that were never tested are not in this data.

Manganese, Iron, and Chloride are widespread in local groundwater. They are mainly a staining and taste problem, but high manganese also carries a health advisory for infants.

What to test for in Crawford County

  1. 1
    Coliform bacteria
    Recommended for every private well, every year.
  2. 2
    Nitrate
    Recommended for every private well, especially near farms or septic systems.
  3. 3
    Fluoride
    Detected in 100% of local samples.
  4. 4
    Manganese
    Detected in 100% of local samples.
  5. 5
    Iron
    Detected in 100% of local samples.
  6. 6
    Chloride
    Detected in 100% of local samples.
  7. 7
    Volatile organic compounds (VOCs)
    210 leaking underground storage tank sites on record locally.
  8. 8
    Metals panel
    9 hazardous waste sites on record locally.

Test your Crawford County well for coliform bacteria, nitrate and fluoride

Certified lab analysis of your own tap water, bottles and prepaid return shipping included. The Essential well panel covers arsenic, uranium, nitrate, lead, copper, manganese, iron, sodium and bacteria; radon and PFAS are add-ons.

Order the Tap Score well water test kit, from $209Already tested? Upload the report

Just want bacteria checked first? Tap Score coliform and E. coli test, $99. Coliform and E. coli are the tests every well needs every year.

Want a quick look before paying for a lab? Home well water test strips on Amazon check hardness, iron, pH and nitrate in minutes. They are a screen, not a result: arsenic, bacteria, uranium and PFAS need a certified lab.

Affiliate links: the merchant pays us a commission and the price is the same for you. It does not change what the data above says. As an Amazon Associate we earn from qualifying purchases.

Where to get a well tested in Ohio: certified labs, state programs and prices.

Already have results back? Get your lab report read against the Crawford County numbers, $29. Every line explained, ranked by what matters, with the fix for each.

Wells in Crawford County

3,463 domestic wells in Crawford County are on record with the state since 1970. 61% are drilled into bedrock, and the typical well is 61 feet deep (one in ten goes past 122 feet).

In a typical Crawford County well, bedrock starts about 44 feet down, the median yield is 10 gallons per minute, 6% of wells yield under 3 gallons per minute and usually need a storage tank.

Bedrock wells are where arsenic, uranium and radon come from: the water sits in fractures in granite and metamorphic rock and picks up whatever the rock carries. That is why testing for those three matters more here than in a dug or gravel well.

633
1970s
192
1980s
340
1990s
570
2000s
261
2010s
50
2020s

Find your own well's report

The state keeps the driller's report for most wells drilled since 1984. It tells you how deep your well is, where bedrock starts, and how much water it makes, which decides what treatment can work.

  1. Open ODNR water well log search and choose Water Well.
  2. The log lists depth, depth to bedrock, casing, static water level, the pump test and the driller.

Ohio has required well logs since 1948, so most drilled wells have one.

The rock under Crawford County

Not a principal aquifer

The USGS map places this area outside any principal aquifer, which usually means wells here draw from fractured bedrock or thin local deposits rather than a large regional aquifer. Bedrock wells of that kind are where arsenic, radon and uranium turn up, and yields vary from well to well.

Classification from the USGS Principal Aquifers of the United States (national map, 2003 edition, GIS release 2015), read at the county centroid. A single well can sit in a different unit, especially near a boundary.

Official help in Ohio

Two places to start that are not selling anything: the state program that answers private well questions, and its list of labs certified to run drinking water tests. A certified lab is the difference between a result you can act on and a number.

Contamination sources on record in Crawford County

Ohio EPA records 210 leaking underground storage tank sites and 9 hazardous waste sites in Crawford County, among 228 regulated sites in total. Groundwater does not follow property lines, so a well within a few hundred feet of one of these is worth testing for what that site could release.

210
leaking underground storage tank sitesGasoline and heating oil that leaked from tanks move through groundwater as benzene, MTBE and other volatile organic compounds.
9
hazardous waste sitesSolvents, degreasers and metals from industrial sites can travel far in fractured bedrock.
4
lined landfills and transfer facilities
5
other remediation projects

Treatment that fits the local profile

Manganese

Oxidizing filter (greensand, birm) whole-house; Water softener (low levels); Point-of-use reverse osmosis

Iron

Oxidizing filter whole-house; Water softener (low levels); Aeration plus filtration

Systems we would look at first

Some links below are affiliate links. If you buy through one, the merchant pays us a commission at no extra cost to you. It does not change which products we list or what the data says.

For manganese

Iron and manganese oxidizing filter

whole-house, at the point of entry, about $1,800

Air-injection or greensand media; fixes staining at the source.

Free, no obligation

Get on the list for a free in-home water test in Crawford County

No water treatment company serves Crawford County through Well Water Nerd yet. We are signing licensed companies on county by county: they test at your tap for free, walk you through the numbers, and quote treatment only if something needs fixing. Leave your details and you are first in line. Nothing is shared until a company joins for Crawford County, and you get an email naming it first.

What are you worried about?

The test is free and there is no obligation. No company is named yet; your details stay with us until one joins for your area, and we log the time and address of this request.

Common questions

How deep are wells in Crawford County?

The typical domestic well in Crawford County is 61 feet deep, based on 3,463 wells reported to the state since 1970. One in ten is deeper than 122 feet. 61% are drilled into bedrock.

How often should I test a private well in Crawford County?

Test for bacteria and nitrate every year. Test once for arsenic, uranium, radon, fluoride, manganese and PFAS, then again every three to five years or after any change in taste, color, or plumbing.

Towns in Crawford County

19 towns have fewer than 30 public samples and are included in the Crawford County totals above rather than shown separately: Auburn township, Bucyrus, Bucyrus township, Chatfield township, Cranberry township, Crestline village, Dallas township, Galion City township, Holmes township, Jackson township, Jefferson township, Liberty township, Lykens township, Polk township, Sandusky township, Texas township, Tod township, Vernon township, Whetstone township.

Counties near Crawford County

Closest first. Groundwater does not stop at a line on a map, so the next county over is a fair second opinion.

Want the numbers themselves? Download the Ohio dataset as CSV, every county and town, with the sources named.

Sources

  • USGS Water Quality Portal: 22 samples in Crawford County. Data from the Water Quality Portal, a service of USGS, EPA and USDA; groundwater samples collected by USGS and cooperators. Retrieved September 3, 2026.
  • USGS national arsenic model (Ayotte 2017): estimated share of 14,014 people on private wells in Crawford County above 10 ug/L of arsenic, from geology, well depth and land use. County estimates of domestic well users with arsenic above 10 ug/L from the USGS national logistic regression model (Ayotte, Medalie and Qi, 2017), with private well population from the USGS 2015 county water-use compilation (Dieter and others, 2018). Retrieved September 15, 2026.
  • Ohio DNR water well logs: 4,408 well records in Crawford County, 3,463 domestic. Water well logs filed with the Ohio Department of Natural Resources Division of Water Resources since 1948. Only aggregates are shown; owner names and addresses are never stored. Retrieved September 17, 2026.
  • Ohio EPA regulated sites: 228 regulated sites located in Crawford County. Remediation sites, leaking underground storage tank releases (BUSTR) and landfills from the Ohio Environmental Protection Agency and the Division of State Fire Marshal. Retrieved September 17, 2026.

Non-detects count as samples and are treated as zero when computing medians. Exactly at the limit counts as not above it. A sample belongs to the town containing the well's reported coordinates.