Well water in Northeastern Connecticut Planning Region, Connecticut
1in9
Testing recommended
tested well samples in Northeastern Connecticut Planning Region exceeded the EPA limit for uranium (30 ug/L), based on public data from USGS Water Quality Portal and Connecticut DPH and USGS arsenic and uranium survey.
860 test results across 13 contaminants from at least 151 wells, 1949 to 2017; iron has the most at 186. Data refreshed September 3, 2026.
Compiled by Nick at Well Water Nerd from public records. How these pages are built
What individual samples found
Each row summarizes every public sample for that contaminant inside Northeastern Connecticut Planning Region. Above limit means above the EPA maximum contaminant level; where EPA has no enforceable limit, the row shows a health guideline or nuisance level instead.
| Contaminant | Above limit | Samples | Detected | Median | Highest | Limit |
|---|---|---|---|---|---|---|
| Uranium 1988 to 2017 | 43 | 56% | 1.8 | 76 | 30 ug/L EPA limit | |
| Arsenic 1995 to 2017 | 56 | 30% | 0 | 29 | 10 ug/L EPA limit | |
| Nitrate 1950 to 2017 | 179 | 98% | 0.971 | 41 | 10 mg/L EPA limit | |
| Fluoride 1962 to 2017 | 31 | 87% | 0.1 | 0.5 | 4 mg/L EPA limit | |
| Radium (226 + 228) 1988 to 2017 | 16 | 38% | 0 | 2 | 5 pCi/L EPA limit | |
| Iron 1950 to 2017 | no limit | 186 | 96% | 60 | 7,600 | 300 ug/L nuisance level |
| Sodium 1962 to 2017 | no limit | 152 | 100% | 5.85 | 50 | 20 mg/L health guideline |
| Manganese 1959 to 2017 | no limit | 103 | 99% | 10 | 3,400 | 300 ug/L health guideline |
| Chloride 1949 to 2017 | no limit | 81 | 100% | 7.2 | 197 | 250 mg/L nuisance level |
Sampled fewer than 10 times, too few to summarize: Copper (3), E. coli (3), Lead (3), Radon (4).
Over time
Share of samples above the limit by period. A cell needs ten samples to show; a comparison needs twenty in each period. Later periods sample fewer wells, and often the ones already known to have a problem.
| Contaminant | before 2000 | 2000s | 2010s | 2020s |
|---|---|---|---|---|
| Arsenic | n/a | 5%19 samples | 11%35 samples | n/a |
| Uranium | 20%20 samples | n/a | 5%21 samples | n/a |
Uranium above the limit in Northeastern Connecticut Planning Region fell from 20% of 20 samples before 2000 to 5% of 21 in the 2010s.
Closer than the county
See the sampled wells near your address
The same records, drawn around one point: which wells within a few miles were sampled and what they found, how deep the wells next to you were drilled, and any leaking tank or cleanup site within a mile.
Check my addressWhat this means
The contaminants most often above their limit here are uranium (12% of 43 samples), arsenic (9% of 56 samples), and nitrate (8% of 179 samples). A well next door can differ sharply from yours because bedrock fractures, well depth and plumbing all matter, so these rates describe the area, not your tap.
Iron, Manganese, and Chloride are widespread in local groundwater. They are mainly a staining and taste problem, but high manganese also carries a health advisory for infants.
The median radon reading (4,380 pCi/L) is above the 2,000 pCi/L level at which treatment is recommended. Radon in water raises indoor air radon when it is used for showers and laundry.
What to test for in Northeastern Connecticut Planning Region
- 1Uranium12% of 43 local samples were above the limit.
- 2Arsenic9% of 56 local samples were above the limit.
- 3Nitrate8% of 179 local samples were above the limit.
- 4Coliform bacteriaRecommended for every private well, every year.
- 5RadonMedian local reading is 4,380 pCi/L.
- 6CopperDetected in 100% of local samples.
- 7ChlorideDetected in 100% of local samples.
- 8Volatile organic compounds (VOCs)179 leaking underground storage tank sites on record locally.
- 9Metals panel6 hazardous waste sites on record locally.
Test your Northeastern Connecticut Planning Region well for uranium, arsenic and nitrate
Certified lab analysis of your own tap water, bottles and prepaid return shipping included. The Essential well panel covers arsenic, uranium, nitrate, lead, copper, manganese, iron, sodium and bacteria; radon and PFAS are add-ons.
Order the Tap Score well water test kit, from $209Already tested? Upload the report
Just want bacteria checked first? Tap Score coliform and E. coli test, $99. Coliform and E. coli are the tests every well needs every year.
Want a quick look before paying for a lab? Home well water test strips on Amazon check hardness, iron, pH and nitrate in minutes. They are a screen, not a result: arsenic, bacteria, uranium and PFAS need a certified lab.
Affiliate links: the merchant pays us a commission and the price is the same for you. It does not change what the data above says. As an Amazon Associate we earn from qualifying purchases.
Where to get a well tested in Connecticut: certified labs, state programs and prices.
Already have results back? Get your lab report read against the Northeastern Connecticut Planning Region numbers, $29. Every line explained, ranked by what matters, with the fix for each.
Wells in Northeastern Connecticut Planning Region
750 domestic wells in Northeastern Connecticut Planning Region are on record with the state since 2020. the typical well is 300 feet deep (one in ten goes past 560 feet).
In a typical Northeastern Connecticut Planning Region well, the median yield is 9 gallons per minute, 15% of wells yield under 3 gallons per minute and usually need a storage tank.
Find your own well's report
The state keeps the driller's report for most wells drilled since 1984. It tells you how deep your well is, where bedrock starts, and how much water it makes, which decides what treatment can work.
- Open Connecticut well completion reports and choose Water Well.
- The report lists depth, depth to rock, casing, static water level and yield.
Only reports filed online since January 2021 are here; older paper reports are held by the Department of Consumer Protection.
The rock under Northeastern Connecticut Planning Region
Not a principal aquifer
The USGS map places this area outside any principal aquifer, which usually means wells here draw from fractured bedrock or thin local deposits rather than a large regional aquifer. Bedrock wells of that kind are where arsenic, radon and uranium turn up, and yields vary from well to well.
Classification from the USGS Principal Aquifers of the United States (national map, 2003 edition, GIS release 2015), read at the planning region centroid. A single well can sit in a different unit, especially near a boundary.
Official help in Connecticut
Two places to start that are not selling anything: the state program that answers private well questions, and its list of labs certified to run drinking water tests. A certified lab is the difference between a result you can act on and a number.
- Private Wells, CT DPH
- Environmental Laboratory Certification, CT DPH
Contamination sources on record in Northeastern Connecticut Planning Region
CT DEEP contaminated sites and landfills records 179 leaking underground storage tank sites, 6 hazardous waste sites, and 13 reported spills and releases in Northeastern Connecticut Planning Region, among 484 regulated sites in total. Groundwater does not follow property lines, so a well within a few hundred feet of one of these is worth testing for what that site could release.
- 179
- leaking underground storage tank sitesGasoline and heating oil that leaked from tanks move through groundwater as benzene, MTBE and other volatile organic compounds.
- 6
- hazardous waste sitesSolvents, degreasers and metals from industrial sites can travel far in fractured bedrock.
- 13
- reported spills and releasesMost spills are fuel; a few are solvents or chemicals that reach the water table.
- 20
- lined landfills and transfer facilities
- 266
- other remediation projects
Treatment that fits the local profile
Uranium
Point-of-use reverse osmosis; Anion exchange; Whole-house anion exchange
Arsenic
Point-of-use reverse osmosis; Adsorptive media (iron-based) whole-house; Anion exchange
Nitrate
Point-of-use reverse osmosis; Anion exchange; Distillation
Radon
Aeration (bubble-up or diffused) whole-house; Granular activated carbon whole-house (lower levels only)
Iron
Oxidizing filter whole-house; Water softener (low levels); Aeration plus filtration
Systems we would look at first
Some links below are affiliate links. If you buy through one, the merchant pays us a commission at no extra cost to you. It does not change which products we list or what the data says.
For uranium
Under-sink reverse osmosis system
under-sink or countertop, about $300
Look for NSF/ANSI 58 certification listing the contaminant you need removed.
For uranium
Whole-house arsenic and uranium filter
whole-house, at the point of entry, about $2,500
Adsorptive iron-based media; sized to your well yield.
For arsenic
Aquasana SmartFlow reverse osmosis
under-sink or countertop, about $225
Certified to NSF/ANSI 58 and 53 to reduce arsenic (96%, pentavalent), fluoride (90%), lead (99%), nitrate, nitrite and PFOA/PFOS at the kitchen tap, with a remineralizer.
For iron
Iron and manganese oxidizing filter
whole-house, at the point of entry, about $1,800
Air-injection or greensand media; fixes staining at the source.
Free, no obligation
Get on the list for a free in-home water test in Northeastern Connecticut Planning Region
No water treatment company serves Northeastern Connecticut Planning Region through Well Water Nerd yet. We are signing licensed companies on county by county: they test at your tap for free, walk you through the numbers, and quote treatment only if something needs fixing. Leave your details and you are first in line. Nothing is shared until a company joins for Northeastern Connecticut Planning Region, and you get an email naming it first.
Common questions
How deep are wells in Northeastern Connecticut Planning Region?
The typical domestic well in Northeastern Connecticut Planning Region is 300 feet deep, based on 750 wells reported to the state since 2020. One in ten is deeper than 560 feet.
Is there arsenic in well water in Northeastern Connecticut Planning Region?
Arsenic was detected in 30% of 56 public well samples in Northeastern Connecticut Planning Region, and 9% were above the EPA limit of 10 ug/L. Arsenic has no taste or smell; a lab test is the only way to know your level.
How often should I test a private well in Northeastern Connecticut Planning Region?
Test for bacteria and nitrate every year. Test once for arsenic, uranium, radon, fluoride, manganese and PFAS, then again every three to five years or after any change in taste, color, or plumbing.
Towns in Northeastern Connecticut Planning Region
15 towns have fewer than 30 public samples and are included in the Northeastern Connecticut Planning Region totals above rather than shown separately: Ashford, Brooklyn, Canterbury, Chaplin, Eastford, Hampton, Killingly, Plainfield, Pomfret, Putnam, Scotland, Sterling, Thompson, Union, Voluntown.
Planning regions near Northeastern Connecticut Planning Region
Closest first. Groundwater does not stop at a line on a map, so the next planning region over is a fair second opinion.
Want the numbers themselves? Download the Connecticut dataset as CSV, every county and town, with the sources named.
Sources
- USGS Water Quality Portal: 806 samples in Northeastern Connecticut Planning Region. Data from the Water Quality Portal, a service of USGS, EPA and USDA; groundwater samples collected by USGS and cooperators. Retrieved September 3, 2026.
- Connecticut DPH and USGS arsenic and uranium survey: 54 samples in Northeastern Connecticut Planning Region. Arsenic and uranium in 674 private bedrock wells sampled by the Connecticut Department of Public Health with the U.S. Geological Survey, 2013 to 2015. Retrieved .
- Connecticut well completion reports: 846 well records in Northeastern Connecticut Planning Region, 750 domestic. Well completion reports filed online with the Connecticut Department of Consumer Protection since January 2021. Only aggregates are shown; owner names and addresses are never stored. Retrieved September 16, 2026.
- CT DEEP contaminated sites and landfills: 484 regulated sites located in Northeastern Connecticut Planning Region. Contaminated or potentially contaminated sites and solid waste landfills from the Connecticut Department of Energy and Environmental Protection. Retrieved September 16, 2026.
Non-detects count as samples and are treated as zero when computing medians. Exactly at the limit counts as not above it. A sample belongs to the town containing the well's reported coordinates.