Well water in Sanborn County, South Dakota

In Sanborn County, none of 97 tested well samples exceeded the EPA limit for nitrate, based on public data from USGS Water Quality Portal.

The strongest signal is arsenic: 6% of 16 local samples were above the limit, too few samples to carry the headline but first on the test list below.

1,116 test results across 11 contaminants from at least 512 wells, 1937 to 1981; chloride has the most at 570. Data refreshed September 3, 2026.

Compiled by Nick at Well Water Nerd from public records. How these pages are built

What individual samples found

Each row summarizes every public sample for that contaminant inside Sanborn County. Above limit means above the EPA maximum contaminant level; where EPA has no enforceable limit, the row shows a health guideline or nuisance level instead.

Contaminant	Above limit	Samples	Detected	Median	Highest	Limit
Arsenic 1978 to 1981	6%	16	25%	0	53	10 ug/L EPA limit
Nitrate 1949 to 1980	0%	97	87%	0.1	9	10 mg/L EPA limit
Fluoride 1937 to 1980	0%	77	100%	1.6	3.4	4 mg/L EPA limit
Copper 1978 to 1981	0%	13	54%	0	0	1.3 mg/L EPA limit
Uranium 1978 to 1979	0%	12	17%	0	28	30 ug/L EPA limit
Chloride 1949 to 1980	no limit	570	100%	150	826	250 mg/L nuisance level
Sodium 1949 to 1980	no limit	129	100%	410	1,080	20 mg/L health guideline
Iron 1954 to 1980	no limit	115	90%	390	50,000	300 ug/L nuisance level
Manganese 1937 to 1980	no limit	83	98%	90	1,800	300 ug/L health guideline

Sampled fewer than 10 times, too few to summarize: Lead (3), Radium (226 + 228) (1).

Closer than the county

See the sampled wells near your address

The same records, drawn around one point: which wells within a few miles were sampled and what they found, how deep the wells next to you were drilled, and any leaking tank or cleanup site within a mile.

Check my address

What this means

The contaminants most often above their limit here are arsenic (6% of 16 samples). A well next door can differ sharply from yours because bedrock fractures, well depth and plumbing all matter, so these rates describe the area, not your tap.

Chloride, Iron, and Manganese are widespread in local groundwater. They are mainly a staining and taste problem, but high manganese also carries a health advisory for infants.

What to test for in Sanborn County

1
Arsenic
6% of 16 local samples were above the limit.
2
Coliform bacteria
Recommended for every private well, every year.
3
Nitrate
Recommended for every private well, especially near farms or septic systems.
4
Fluoride
Detected in 100% of local samples.
5
Chloride
Detected in 100% of local samples.
6
Manganese
Detected in 98% of local samples.
7
Iron
Detected in 90% of local samples.
8
Volatile organic compounds (VOCs)
56 reported spills and releases on record locally.

Test your Sanborn County well for arsenic, coliform bacteria and nitrate

Certified lab analysis of your own tap water, bottles and prepaid return shipping included. The Essential well panel covers arsenic, uranium, nitrate, lead, copper, manganese, iron, sodium and bacteria; radon and PFAS are add-ons.

Order the Tap Score well water test kit, from $209 Already tested? Upload the report

Just want bacteria checked first? Tap Score coliform and E. coli test, $99. Coliform and E. coli are the tests every well needs every year.

Want a quick look before paying for a lab? Home well water test strips on Amazon check hardness, iron, pH and nitrate in minutes. They are a screen, not a result: arsenic, bacteria, uranium and PFAS need a certified lab.

Affiliate links: the merchant pays us a commission and the price is the same for you. It does not change what the data above says. As an Amazon Associate we earn from qualifying purchases.

Where to get a well tested in South Dakota: certified labs, state programs and prices.

Already have results back? Get your lab report read against the Sanborn County numbers, $29. Every line explained, ranked by what matters, with the fix for each.

Wells in Sanborn County

1,008 domestic wells in Sanborn County are on record with the state since 1970. the typical well is 200 feet deep (one in ten goes past 961 feet).

1970s

125

1980s

1990s

222

2000s

113

2010s

2020s

Find your own well's report

The state keeps the driller's report for most wells drilled since 1984. It tells you how deep your well is, where bedrock starts, and how much water it makes, which decides what treatment can work.

Open DANR well completion reports and choose Water Well.
It lists depth, aquifer, static water level and the driller.

South Dakota has required reports since 1986.

The rock under Sanborn County

Not a principal aquifer

The USGS map places this area outside any principal aquifer, which usually means wells here draw from fractured bedrock or thin local deposits rather than a large regional aquifer. Bedrock wells of that kind are where arsenic, radon and uranium turn up, and yields vary from well to well.

Classification from the USGS Principal Aquifers of the United States (national map, 2003 edition, GIS release 2015), read at the county centroid. A single well can sit in a different unit, especially near a boundary.

Official help in South Dakota

Two places to start that are not selling anything: the state program that answers private well questions, and its list of labs certified to run drinking water tests. A certified lab is the difference between a result you can act on and a number.

Test a Private Well, South Dakota Department of Health
Drinking Water Program - Laboratory Certification, South Dakota DANR

Contamination sources on record in Sanborn County

South Dakota DANR tank facilities and spills records 56 reported spills and releases in Sanborn County, among 77 regulated sites in total. Groundwater does not follow property lines, so a well within a few hundred feet of one of these is worth testing for what that site could release.

56: reported spills and releasesMost spills are fuel; a few are solvents or chemicals that reach the water table.
10: registered underground storage tank sitesRegistered tanks are regulated and inspected; they matter most when they are old or near a shallow well.
11: other solid waste facilities

Treatment that fits the local profile

Arsenic

Point-of-use reverse osmosis; Adsorptive media (iron-based) whole-house; Anion exchange

Fluoride

Point-of-use reverse osmosis; Activated alumina; Distillation

Manganese

Oxidizing filter (greensand, birm) whole-house; Water softener (low levels); Point-of-use reverse osmosis

Iron

Oxidizing filter whole-house; Water softener (low levels); Aeration plus filtration

Systems we would look at first

Some links below are affiliate links. If you buy through one, the merchant pays us a commission at no extra cost to you. It does not change which products we list or what the data says.

For arsenic

Under-sink reverse osmosis system

under-sink or countertop, about $300

Look for NSF/ANSI 58 certification listing the contaminant you need removed.

For arsenic

Whole-house arsenic and uranium filter

whole-house, at the point of entry, about $2,500

Adsorptive iron-based media; sized to your well yield.

For arsenic

Aquasana SmartFlow reverse osmosis

under-sink or countertop, about $225

Certified to NSF/ANSI 58 and 53 to reduce arsenic (96%, pentavalent), fluoride (90%), lead (99%), nitrate, nitrite and PFOA/PFOS at the kitchen tap, with a remineralizer.

For iron

Iron and manganese oxidizing filter

whole-house, at the point of entry, about $1,800

Air-injection or greensand media; fixes staining at the source.

Free, no obligation

Get on the list for a free in-home water test in Sanborn County

No water treatment company serves Sanborn County through Well Water Nerd yet. We are signing licensed companies on county by county: they test at your tap for free, walk you through the numbers, and quote treatment only if something needs fixing. Leave your details and you are first in line. Nothing is shared until a company joins for Sanborn County, and you get an email naming it first.

Common questions

How deep are wells in Sanborn County?

The typical domestic well in Sanborn County is 200 feet deep, based on 1,008 wells reported to the state since 1970. One in ten is deeper than 961 feet.

Is there arsenic in well water in Sanborn County?

Arsenic was detected in 25% of 16 public well samples in Sanborn County, and 6% were above the EPA limit of 10 ug/L. Arsenic has no taste or smell; a lab test is the only way to know your level.

How often should I test a private well in Sanborn County?

Test for bacteria and nitrate every year. Test once for arsenic, uranium, radon, fluoride, manganese and PFAS, then again every three to five years or after any change in taste, color, or plumbing.

Counties near Sanborn County

Closest first. Groundwater does not stop at a line on a map, so the next county over is a fair second opinion.

Want the numbers themselves? Download the South Dakota dataset as CSV, every county and town, with the sources named.

Sources

USGS Water Quality Portal: 1,116 samples in Sanborn County. Data from the Water Quality Portal, a service of USGS, EPA and USDA; groundwater samples collected by USGS and cooperators. Retrieved September 3, 2026.
South Dakota DANR well completion reports: 1,304 well records in Sanborn County, 1,008 domestic. Well completion reports filed with the South Dakota Department of Agriculture and Natural Resources. Only aggregates are shown; owner names and addresses are never stored. Retrieved September 18, 2026.
South Dakota DANR tank facilities and spills: 77 regulated sites located in Sanborn County. Regulated tank facilities and spill reports from the South Dakota Department of Agriculture and Natural Resources. Retrieved September 18, 2026.

Non-detects count as samples and are treated as zero when computing medians. Exactly at the limit counts as not above it. A sample belongs to the town containing the well's reported coordinates.