Well Water Nerd

Well water in Brule County, South Dakota

In Brule County, none of 32 tested well samples exceeded the EPA limit for fluoride, based on public data from USGS Water Quality Portal.

The strongest signal is coliform bacteria: Recommended for every private well, every year, too few samples to carry the headline but first on the test list below.

209 test results across 8 contaminants from at least 38 wells, 1938 to 1981; chloride has the most at 60. Data refreshed September 3, 2026.

Compiled by Nick at Well Water Nerd from public records. How these pages are built

What individual samples found

Each row summarizes every public sample for that contaminant inside Brule County. Above limit means above the EPA maximum contaminant level; where EPA has no enforceable limit, the row shows a health guideline or nuisance level instead.

ContaminantAbove limitSamplesDetectedMedianHighestLimit
Fluoride
1938 to 1979
32100%2.853.44 mg/L
EPA limit
Nitrate
1956 to 1979
2650%00.310 mg/L
EPA limit
Chloride
1938 to 1981
no limit60100%113625250 mg/L
nuisance level
Sodium
1956 to 1981
no limit31100%9495320 mg/L
health guideline
Iron
1938 to 1979
no limit29100%2,5009,700300 ug/L
nuisance level
Manganese
1956 to 1979
no limit27100%1303,500300 ug/L
health guideline

Sampled fewer than 10 times, too few to summarize: Arsenic (2), Lead (2).

Closer than the county

See the sampled wells near your address

The same records, drawn around one point: which wells within a few miles were sampled and what they found, how deep the wells next to you were drilled, and any leaking tank or cleanup site within a mile.

Check my address

What this means

Among contaminants with a federal limit, no tested sample in Brule County came back above it. That is reassuring, but sampling is uneven: wells that were never tested are not in this data.

Chloride, Iron, and Manganese are widespread in local groundwater. They are mainly a staining and taste problem, but high manganese also carries a health advisory for infants.

What to test for in Brule County

  1. 1
    Coliform bacteria
    Recommended for every private well, every year.
  2. 2
    Nitrate
    Recommended for every private well, especially near farms or septic systems.
  3. 3
    Fluoride
    Detected in 100% of local samples.
  4. 4
    Chloride
    Detected in 100% of local samples.
  5. 5
    Iron
    Detected in 100% of local samples.
  6. 6
    Manganese
    Detected in 100% of local samples.
  7. 7
    Volatile organic compounds (VOCs)
    184 reported spills and releases on record locally.

Test your Brule County well for coliform bacteria, nitrate and fluoride

Certified lab analysis of your own tap water, bottles and prepaid return shipping included. The Essential well panel covers arsenic, uranium, nitrate, lead, copper, manganese, iron, sodium and bacteria; radon and PFAS are add-ons.

Order the Tap Score well water test kit, from $209Already tested? Upload the report

Just want bacteria checked first? Tap Score coliform and E. coli test, $99. Coliform and E. coli are the tests every well needs every year.

Want a quick look before paying for a lab? Home well water test strips on Amazon check hardness, iron, pH and nitrate in minutes. They are a screen, not a result: arsenic, bacteria, uranium and PFAS need a certified lab.

Affiliate links: the merchant pays us a commission and the price is the same for you. It does not change what the data above says. As an Amazon Associate we earn from qualifying purchases.

Where to get a well tested in South Dakota: certified labs, state programs and prices.

Already have results back? Get your lab report read against the Brule County numbers, $29. Every line explained, ranked by what matters, with the fix for each.

Wells in Brule County

395 domestic wells in Brule County are on record with the state since 1970. the typical well is 920 feet deep (one in ten goes past 1,066 feet).

85
1970s
19
1980s
23
1990s
58
2000s
16
2010s
6
2020s

Find your own well's report

The state keeps the driller's report for most wells drilled since 1984. It tells you how deep your well is, where bedrock starts, and how much water it makes, which decides what treatment can work.

  1. Open DANR well completion reports and choose Water Well.
  2. It lists depth, aquifer, static water level and the driller.

South Dakota has required reports since 1986.

The rock under Brule County

Not a principal aquifer

The USGS map places this area outside any principal aquifer, which usually means wells here draw from fractured bedrock or thin local deposits rather than a large regional aquifer. Bedrock wells of that kind are where arsenic, radon and uranium turn up, and yields vary from well to well.

Classification from the USGS Principal Aquifers of the United States (national map, 2003 edition, GIS release 2015), read at the county centroid. A single well can sit in a different unit, especially near a boundary.

Official help in South Dakota

Two places to start that are not selling anything: the state program that answers private well questions, and its list of labs certified to run drinking water tests. A certified lab is the difference between a result you can act on and a number.

Contamination sources on record in Brule County

South Dakota DANR tank facilities and spills records 184 reported spills and releases in Brule County, among 236 regulated sites in total. Groundwater does not follow property lines, so a well within a few hundred feet of one of these is worth testing for what that site could release.

184
reported spills and releasesMost spills are fuel; a few are solvents or chemicals that reach the water table.
31
registered underground storage tank sitesRegistered tanks are regulated and inspected; they matter most when they are old or near a shallow well.
21
other solid waste facilities

Treatment that fits the local profile

Fluoride

Point-of-use reverse osmosis; Activated alumina; Distillation

Iron

Oxidizing filter whole-house; Water softener (low levels); Aeration plus filtration

Manganese

Oxidizing filter (greensand, birm) whole-house; Water softener (low levels); Point-of-use reverse osmosis

Systems we would look at first

Some links below are affiliate links. If you buy through one, the merchant pays us a commission at no extra cost to you. It does not change which products we list or what the data says.

For fluoride

Under-sink reverse osmosis system

under-sink or countertop, about $300

Look for NSF/ANSI 58 certification listing the contaminant you need removed.

For fluoride

Aquasana SmartFlow reverse osmosis

under-sink or countertop, about $225

Certified to NSF/ANSI 58 and 53 to reduce arsenic (96%, pentavalent), fluoride (90%), lead (99%), nitrate, nitrite and PFOA/PFOS at the kitchen tap, with a remineralizer.

For iron

Iron and manganese oxidizing filter

whole-house, at the point of entry, about $1,800

Air-injection or greensand media; fixes staining at the source.

Free, no obligation

Get on the list for a free in-home water test in Brule County

No water treatment company serves Brule County through Well Water Nerd yet. We are signing licensed companies on county by county: they test at your tap for free, walk you through the numbers, and quote treatment only if something needs fixing. Leave your details and you are first in line. Nothing is shared until a company joins for Brule County, and you get an email naming it first.

What are you worried about?

The test is free and there is no obligation. No company is named yet; your details stay with us until one joins for your area, and we log the time and address of this request.

Common questions

How deep are wells in Brule County?

The typical domestic well in Brule County is 920 feet deep, based on 395 wells reported to the state since 1970. One in ten is deeper than 1,066 feet.

How often should I test a private well in Brule County?

Test for bacteria and nitrate every year. Test once for arsenic, uranium, radon, fluoride, manganese and PFAS, then again every three to five years or after any change in taste, color, or plumbing.

Counties near Brule County

Closest first. Groundwater does not stop at a line on a map, so the next county over is a fair second opinion.

Want the numbers themselves? Download the South Dakota dataset as CSV, every county and town, with the sources named.

Sources

  • USGS Water Quality Portal: 209 samples in Brule County. Data from the Water Quality Portal, a service of USGS, EPA and USDA; groundwater samples collected by USGS and cooperators. Retrieved September 3, 2026.
  • South Dakota DANR well completion reports: 847 well records in Brule County, 395 domestic. Well completion reports filed with the South Dakota Department of Agriculture and Natural Resources. Only aggregates are shown; owner names and addresses are never stored. Retrieved September 18, 2026.
  • South Dakota DANR tank facilities and spills: 236 regulated sites located in Brule County. Regulated tank facilities and spill reports from the South Dakota Department of Agriculture and Natural Resources. Retrieved September 18, 2026.

Non-detects count as samples and are treated as zero when computing medians. Exactly at the limit counts as not above it. A sample belongs to the town containing the well's reported coordinates.