Well water in Greenville County, South Carolina
No public well test results have been compiled for Greenville County yet. The USGS national arsenic model estimates that <1% of the 32,576 people on private wells there draw water with arsenic above 10 ug/L, the EPA limit, based on geology, well depth and land use rather than local tests.
The strongest signal is nitrate: 7% of 14 local samples were above the limit, too few samples to carry the headline but first on the test list below.
107 test results across 13 contaminants from at least 13 wells, 1962 to 2014; nitrate has the most at 14. Data refreshed September 15, 2026.
Compiled by Nick at Well Water Nerd from public records. How these pages are built
An estimated 32,576 people in Greenville County get their drinking water from a private well, per USGS 2015 county water use. That is about 7% of residents.
Separately, the USGS national arsenic model estimates that <1% of the 32,576 people on private wells in Greenville County draw water above 10 ug/L (the model's range is <1% to 1%), from geology and well depth rather than local tests.
What individual samples found
Each row summarizes every public sample for that contaminant inside Greenville County. Above limit means above the EPA maximum contaminant level; where EPA has no enforceable limit, the row shows a health guideline or nuisance level instead.
| Contaminant | Above limit | Samples | Detected | Median | Highest | Limit |
|---|---|---|---|---|---|---|
| Nitrate 1962 to 2014 | 14 | 100% | 0.758 | 21 | 10 mg/L EPA limit | |
| Fluoride 1962 to 2014 | 13 | 92% | 0.03 | 0.24 | 4 mg/L EPA limit | |
| Manganese 1962 to 2014 | no limit | 14 | 86% | 15.8 | 170 | 300 ug/L health guideline |
| Chloride 1962 to 2014 | no limit | 13 | 100% | 3.6 | 13.5 | 250 mg/L nuisance level |
| Sodium 1962 to 2014 | no limit | 13 | 100% | 7.4 | 12 | 20 mg/L health guideline |
| Iron 1962 to 2014 | no limit | 13 | 85% | 60 | 1,910 | 300 ug/L nuisance level |
Sampled fewer than 10 times, too few to summarize: Radium (226 + 228) (4), Lead (4), Arsenic (4), Uranium (4), Copper (4), E. coli (3), Radon (4).
Closer than the county
See the sampled wells near your address
The same records, drawn around one point: which wells within a few miles were sampled and what they found, how deep the wells next to you were drilled, and any leaking tank or cleanup site within a mile.
Check my addressWhat this means
The contaminants most often above their limit here are nitrate (7% of 14 samples). A well next door can differ sharply from yours because bedrock fractures, well depth and plumbing all matter, so these rates describe the area, not your tap.
Manganese, Chloride, and Iron are widespread in local groundwater. They are mainly a staining and taste problem, but high manganese also carries a health advisory for infants.
The median radon reading (3,425 pCi/L) is above the 2,000 pCi/L level at which treatment is recommended. Radon in water raises indoor air radon when it is used for showers and laundry.
What to test for in Greenville County
- 1Nitrate7% of 14 local samples were above the limit.
- 2Coliform bacteriaRecommended for every private well, every year.
- 3RadonMedian local reading is 3,425 pCi/L.
- 4CopperDetected in 100% of local samples.
- 5ChlorideDetected in 100% of local samples.
- 6FluorideDetected in 92% of local samples.
- 7ManganeseDetected in 86% of local samples.
Test your Greenville County well for nitrate, coliform bacteria and radon
Certified lab analysis of your own tap water, bottles and prepaid return shipping included. The Essential well panel covers arsenic, uranium, nitrate, lead, copper, manganese, iron, sodium and bacteria; radon and PFAS are add-ons.
Order the Tap Score well water test kit, from $209Already tested? Upload the report
Just want bacteria checked first? Tap Score coliform and E. coli test, $99. Coliform and E. coli are the tests every well needs every year.
Want a quick look before paying for a lab? Home well water test strips on Amazon check hardness, iron, pH and nitrate in minutes. They are a screen, not a result: arsenic, bacteria, uranium and PFAS need a certified lab.
Affiliate links: the merchant pays us a commission and the price is the same for you. It does not change what the data above says. As an Amazon Associate we earn from qualifying purchases.
Where to get a well tested in South Carolina: certified labs, state programs and prices.
Already have results back? Get your lab report read against the Greenville County numbers, $29. Every line explained, ranked by what matters, with the fix for each.
The rock under Greenville County
Piedmont and Blue Ridge crystalline-rock aquifers
Igneous and metamorphic-rock. Granite and similar crystalline rock hold water only in fractures. Wells are deep and yields modest, and the rock itself is the source of arsenic, radon and uranium, which is why those three head the test list in bedrock country.
Classification from the USGS Principal Aquifers of the United States (national map, 2003 edition, GIS release 2015), read at the county centroid. A single well can sit in a different unit, especially near a boundary.
Official help in South Carolina
Two places to start that are not selling anything: the state program that answers private well questions, and its list of labs certified to run drinking water tests. A certified lab is the difference between a result you can act on and a number.
Treatment that fits the local profile
Nitrate
Point-of-use reverse osmosis; Anion exchange; Distillation
Radon
Aeration (bubble-up or diffused) whole-house; Granular activated carbon whole-house (lower levels only)
Manganese
Oxidizing filter (greensand, birm) whole-house; Water softener (low levels); Point-of-use reverse osmosis
Iron
Oxidizing filter whole-house; Water softener (low levels); Aeration plus filtration
Systems we would look at first
Some links below are affiliate links. If you buy through one, the merchant pays us a commission at no extra cost to you. It does not change which products we list or what the data says.
For nitrate
Under-sink reverse osmosis system
under-sink or countertop, about $300
Look for NSF/ANSI 58 certification listing the contaminant you need removed.
For nitrate
Aquasana SmartFlow reverse osmosis
under-sink or countertop, about $225
Certified to NSF/ANSI 58 and 53 to reduce arsenic (96%, pentavalent), fluoride (90%), lead (99%), nitrate, nitrite and PFOA/PFOS at the kitchen tap, with a remineralizer.
For manganese
Iron and manganese oxidizing filter
whole-house, at the point of entry, about $1,800
Air-injection or greensand media; fixes staining at the source.
Free, no obligation
Get on the list for a free in-home water test in Greenville County
No water treatment company serves Greenville County through Well Water Nerd yet. We are signing licensed companies on county by county: they test at your tap for free, walk you through the numbers, and quote treatment only if something needs fixing. Leave your details and you are first in line. Nothing is shared until a company joins for Greenville County, and you get an email naming it first.
Common questions
How often should I test a private well in Greenville County?
Test for bacteria and nitrate every year. Test once for arsenic, uranium, radon, fluoride, manganese and PFAS, then again every three to five years or after any change in taste, color, or plumbing.
Counties near Greenville County
Closest first. Groundwater does not stop at a line on a map, so the next county over is a fair second opinion.
Want the numbers themselves? Download the South Carolina dataset as CSV, every county and town, with the sources named.
Sources
- USGS Water Quality Portal: 107 samples in Greenville County. Data from the Water Quality Portal, a service of USGS, EPA and USDA; groundwater samples collected by USGS and cooperators. Retrieved September 3, 2026.
- USGS national arsenic model (Ayotte 2017): estimated share of 32,576 people on private wells in Greenville County above 10 ug/L of arsenic, from geology, well depth and land use. County estimates of domestic well users with arsenic above 10 ug/L from the USGS national logistic regression model (Ayotte, Medalie and Qi, 2017), with private well population from the USGS 2015 county water-use compilation (Dieter and others, 2018). Retrieved September 15, 2026.
Non-detects count as samples and are treated as zero when computing medians. Exactly at the limit counts as not above it. A sample belongs to the town containing the well's reported coordinates.