Well Water Nerd

Well water in Wayne County, New York

In Wayne County, none of 40 tested well samples exceeded the EPA limit for fluoride, based on public data from USGS Water Quality Portal.

The strongest signal is arsenic: 5% of 19 local samples were above the limit, too few samples to carry the headline but first on the test list below.

335 test results across 12 contaminants from at least 67 wells, 1965 to 2022; chloride has the most at 71. Data refreshed September 15, 2026.

Compiled by Nick at Well Water Nerd from public records. How these pages are built

An estimated 22,740 people in Wayne County get their drinking water from a private well, per USGS 2015 county water use. That is about 25% of residents.

Separately, the USGS national arsenic model estimates that 2% of the 22,740 people on private wells in Wayne County draw water above 10 ug/L (the model's range is 1% to 3%), from geology and well depth rather than local tests.

What individual samples found

Each row summarizes every public sample for that contaminant inside Wayne County. Above limit means above the EPA maximum contaminant level; where EPA has no enforceable limit, the row shows a health guideline or nuisance level instead.

ContaminantAbove limitSamplesDetectedMedianHighestLimit
Arsenic
1972 to 2022
1979%0.7511.510 ug/L
EPA limit
Fluoride
1965 to 2022
40100%0.32.274 mg/L
EPA limit
Lead
1972 to 2022
1953%0.041.0815 ug/L
EPA limit
Copper
1972 to 2022
1995%0.0010.031.3 mg/L
EPA limit
Nitrate
1973 to 2022
1540%02.110 mg/L
EPA limit
Uranium
2007 to 2022
1493%0.335130 ug/L
EPA limit
Chloride
1965 to 2022
no limit71100%247,250250 mg/L
nuisance level
Sodium
1965 to 2022
no limit40100%2166020 mg/L
health guideline
Manganese
1965 to 2022
no limit3897%50490300 ug/L
health guideline
Iron
1965 to 2022
no limit38100%36.42,400300 ug/L
nuisance level
Radon
2007 to 2022
no limit14100%1617402,000 pCi/L
health guideline

Sampled fewer than 10 times, too few to summarize: E. coli (8).

Closer than the county

See the sampled wells near your address

The same records, drawn around one point: which wells within a few miles were sampled and what they found, how deep the wells next to you were drilled, and any leaking tank or cleanup site within a mile.

Check my address

What this means

The contaminants most often above their limit here are arsenic (5% of 19 samples). A well next door can differ sharply from yours because bedrock fractures, well depth and plumbing all matter, so these rates describe the area, not your tap.

Chloride, Manganese, and Iron are widespread in local groundwater. They are mainly a staining and taste problem, but high manganese also carries a health advisory for infants.

What to test for in Wayne County

  1. 1
    Arsenic
    5% of 19 local samples were above the limit.
  2. 2
    Coliform bacteria
    Recommended for every private well, every year.
  3. 3
    Radon
    Median local reading is 161 pCi/L.
  4. 4
    Nitrate
    Recommended for every private well, especially near farms or septic systems.
  5. 5
    Fluoride
    Detected in 100% of local samples.
  6. 6
    Chloride
    Detected in 100% of local samples.
  7. 7
    Iron
    Detected in 100% of local samples.
  8. 8
    Volatile organic compounds (VOCs)
    28 hazardous waste sites on record locally.
  9. 9
    Metals panel
    28 hazardous waste sites on record locally.

Test your Wayne County well for arsenic, coliform bacteria and radon

Certified lab analysis of your own tap water, bottles and prepaid return shipping included. The Essential well panel covers arsenic, uranium, nitrate, lead, copper, manganese, iron, sodium and bacteria; radon and PFAS are add-ons.

Order the Tap Score well water test kit, from $209Already tested? Upload the report

Just want bacteria checked first? Tap Score coliform and E. coli test, $99. Coliform and E. coli are the tests every well needs every year.

Want a quick look before paying for a lab? Home well water test strips on Amazon check hardness, iron, pH and nitrate in minutes. They are a screen, not a result: arsenic, bacteria, uranium and PFAS need a certified lab.

Affiliate links: the merchant pays us a commission and the price is the same for you. It does not change what the data above says. As an Amazon Associate we earn from qualifying purchases.

Where to get a well tested in New York: certified labs, state programs and prices.

Already have results back? Get your lab report read against the Wayne County numbers, $29. Every line explained, ranked by what matters, with the fix for each.

Wells in Wayne County

579 domestic wells in Wayne County are on record with the state. the typical well is 80 feet deep (one in ten goes past 137 feet).

Find your own well's report

The state keeps the driller's report for most wells drilled since 1984. It tells you how deep your well is, where bedrock starts, and how much water it makes, which decides what treatment can work.

  1. Open NYSDEC water well completion reports and choose Water Well.
  2. The report lists depth, depth to bedrock, cased depth, yield and the driller.

Drillers have filed reports with the state since April 2000; a well drilled before then usually has no record.

The rock under Wayne County

New York and New England carbonate-rock aquifers

Carbonate-rock. Limestone and dolomite move water through cracks and solution channels, sometimes very fast. Bacteria and nitrate can travel from the surface to a well in days, so annual bacteria testing matters more here than most places; hardness is a given.

Classification from the USGS Principal Aquifers of the United States (national map, 2003 edition, GIS release 2015), read at the county centroid. A single well can sit in a different unit, especially near a boundary.

Official help in New York

Two places to start that are not selling anything: the state program that answers private well questions, and its list of labs certified to run drinking water tests. A certified lab is the difference between a result you can act on and a number.

Contamination sources on record in Wayne County

NYSDEC remediation sites records 28 hazardous waste sites in Wayne County, among 42 regulated sites in total. Groundwater does not follow property lines, so a well within a few hundred feet of one of these is worth testing for what that site could release.

28
hazardous waste sitesSolvents, degreasers and metals from industrial sites can travel far in fractured bedrock.
14
other remediation projects

Treatment that fits the local profile

Arsenic

Point-of-use reverse osmosis; Adsorptive media (iron-based) whole-house; Anion exchange

Chloride

Point-of-use reverse osmosis; Distillation

Iron

Oxidizing filter whole-house; Water softener (low levels); Aeration plus filtration

Manganese

Oxidizing filter (greensand, birm) whole-house; Water softener (low levels); Point-of-use reverse osmosis

Systems we would look at first

Some links below are affiliate links. If you buy through one, the merchant pays us a commission at no extra cost to you. It does not change which products we list or what the data says.

For arsenic

Under-sink reverse osmosis system

under-sink or countertop, about $300

Look for NSF/ANSI 58 certification listing the contaminant you need removed.

For arsenic

Whole-house arsenic and uranium filter

whole-house, at the point of entry, about $2,500

Adsorptive iron-based media; sized to your well yield.

For arsenic

Aquasana SmartFlow reverse osmosis

under-sink or countertop, about $225

Certified to NSF/ANSI 58 and 53 to reduce arsenic (96%, pentavalent), fluoride (90%), lead (99%), nitrate, nitrite and PFOA/PFOS at the kitchen tap, with a remineralizer.

For manganese

Iron and manganese oxidizing filter

whole-house, at the point of entry, about $1,800

Air-injection or greensand media; fixes staining at the source.

Free, no obligation

Get on the list for a free in-home water test in Wayne County

No water treatment company serves Wayne County through Well Water Nerd yet. We are signing licensed companies on county by county: they test at your tap for free, walk you through the numbers, and quote treatment only if something needs fixing. Leave your details and you are first in line. Nothing is shared until a company joins for Wayne County, and you get an email naming it first.

What are you worried about?

The test is free and there is no obligation. No company is named yet; your details stay with us until one joins for your area, and we log the time and address of this request.

Common questions

How deep are wells in Wayne County?

The typical domestic well in Wayne County is 80 feet deep, based on 579 wells reported to the state. One in ten is deeper than 137 feet.

Is there arsenic in well water in Wayne County?

Arsenic was detected in 79% of 19 public well samples in Wayne County, and 5% were above the EPA limit of 10 ug/L. Arsenic has no taste or smell; a lab test is the only way to know your level.

How high is radon in well water in Wayne County?

The median radon level across 14 public samples in Wayne County was 161 pCi/L, with a high of 740 pCi/L. New Hampshire recommends treatment above 2,000 pCi/L.

How often should I test a private well in Wayne County?

Test for bacteria and nitrate every year. Test once for arsenic, uranium, radon, fluoride, manganese and PFAS, then again every three to five years or after any change in taste, color, or plumbing.

Towns in Wayne County

15 towns have fewer than 30 public samples and are included in the Wayne County totals above rather than shown separately: Arcadia, Butler, Galen, Huron, Lyons, Macedon, Marion, Ontario, Palmyra, Rose, Savannah, Sodus, Walworth, Williamson, Wolcott.

Counties near Wayne County

Closest first. Groundwater does not stop at a line on a map, so the next county over is a fair second opinion.

Want the numbers themselves? Download the New York dataset as CSV, every county and town, with the sources named.

Sources

  • USGS Water Quality Portal: 335 samples in Wayne County. Data from the Water Quality Portal, a service of USGS, EPA and USDA; groundwater samples collected by USGS and cooperators. Retrieved September 3, 2026.
  • USGS national arsenic model (Ayotte 2017): estimated share of 22,740 people on private wells in Wayne County above 10 ug/L of arsenic, from geology, well depth and land use. County estimates of domestic well users with arsenic above 10 ug/L from the USGS national logistic regression model (Ayotte, Medalie and Qi, 2017), with private well population from the USGS 2015 county water-use compilation (Dieter and others, 2018). Retrieved September 15, 2026.
  • NYSDEC water well completion reports: 653 well records in Wayne County, 579 domestic. Water well completion reports filed with the New York State Department of Environmental Conservation Water Well Contractor Program since 2000. Only aggregates are shown; owner names and addresses are never stored. Retrieved September 16, 2026.
  • NYSDEC remediation sites: 42 regulated sites located in Wayne County. State Superfund, brownfield, voluntary cleanup, RCRA and spill remediation sites from the New York State Department of Environmental Conservation Environmental Remediation Sites database. Retrieved September 16, 2026.

Non-detects count as samples and are treated as zero when computing medians. Exactly at the limit counts as not above it. A sample belongs to the town containing the well's reported coordinates.