Well Water Nerd

Well water in Hamilton County, New York

1in12

Testing recommended

tested well samples in Hamilton County exceeded the EPA limit for nitrate (10 mg/L), based on public data from USGS Water Quality Portal.

The strongest signal is uranium: 12% of 17 local samples were above the limit, too few samples to carry the headline but first on the test list below.

494 test results across 11 contaminants from at least 24 wells, 1967 to 2022; nitrate has the most at 178. Data refreshed September 15, 2026.

Compiled by Nick at Well Water Nerd from public records. How these pages are built

An estimated 2,236 people in Hamilton County get their drinking water from a private well, per USGS 2015 county water use. That is about 47% of residents.

Separately, the USGS national arsenic model estimates that 1% of the 2,236 people on private wells in Hamilton County draw water above 10 ug/L (the model's range is <1% to 2%), from geology and well depth rather than local tests.

What individual samples found

Each row summarizes every public sample for that contaminant inside Hamilton County. Above limit means above the EPA maximum contaminant level; where EPA has no enforceable limit, the row shows a health guideline or nuisance level instead.

ContaminantAbove limitSamplesDetectedMedianHighestLimit
Uranium
2005 to 2022
1794%0.97190.630 ug/L
EPA limit
Nitrate
1967 to 2022
17896%2.641510 mg/L
EPA limit
Fluoride
1967 to 2022
1995%0.221.494 mg/L
EPA limit
Lead
2005 to 2022
1788%0.151.3715 ug/L
EPA limit
Arsenic
2005 to 2022
1741%00.7610 ug/L
EPA limit
Copper
2005 to 2022
1776%0.0030.0451.3 mg/L
EPA limit
E. coli
2007 to 2022
140%000 MPN/100mL
EPA limit
Chloride
1967 to 2022
no limit162100%0.51,440250 mg/L
nuisance level
Manganese
1967 to 2022
no limit1867%1.36374300 ug/L
health guideline
Iron
1967 to 2022
no limit1856%8.22,950300 ug/L
nuisance level
Radon
2005 to 2022
no limit17100%99018,8002,000 pCi/L
health guideline

Over time

Share of samples above the limit by period. A cell needs ten samples to show; a comparison needs twenty in each period. Later periods sample fewer wells, and often the ones already known to have a problem.

Contaminantbefore 20002000s2010s2020s
Nitrate10%144 samples0%12 samples0%16 samplesn/a

Closer than the county

See the sampled wells near your address

The same records, drawn around one point: which wells within a few miles were sampled and what they found, how deep the wells next to you were drilled, and any leaking tank or cleanup site within a mile.

Check my address

What this means

The contaminants most often above their limit here are uranium (12% of 17 samples) and nitrate (8% of 178 samples). A well next door can differ sharply from yours because bedrock fractures, well depth and plumbing all matter, so these rates describe the area, not your tap.

Chloride, Manganese, and Iron are widespread in local groundwater. They are mainly a staining and taste problem, but high manganese also carries a health advisory for infants.

What to test for in Hamilton County

  1. 1
    Uranium
    12% of 17 local samples were above the limit.
  2. 2
    Nitrate
    8% of 178 local samples were above the limit.
  3. 3
    Coliform bacteria
    Recommended for every private well, every year.
  4. 4
    Radon
    Median local reading is 990 pCi/L.
  5. 5
    Chloride
    Detected in 100% of local samples.
  6. 6
    Fluoride
    Detected in 95% of local samples.
  7. 7
    Copper
    Detected in 76% of local samples.

Test your Hamilton County well for uranium, nitrate and coliform bacteria

Certified lab analysis of your own tap water, bottles and prepaid return shipping included. The Essential well panel covers arsenic, uranium, nitrate, lead, copper, manganese, iron, sodium and bacteria; radon and PFAS are add-ons.

Order the Tap Score well water test kit, from $209Already tested? Upload the report

Just want bacteria checked first? Tap Score coliform and E. coli test, $99. Coliform and E. coli are the tests every well needs every year.

Want a quick look before paying for a lab? Home well water test strips on Amazon check hardness, iron, pH and nitrate in minutes. They are a screen, not a result: arsenic, bacteria, uranium and PFAS need a certified lab.

Affiliate links: the merchant pays us a commission and the price is the same for you. It does not change what the data above says. As an Amazon Associate we earn from qualifying purchases.

Where to get a well tested in New York: certified labs, state programs and prices.

Already have results back? Get your lab report read against the Hamilton County numbers, $29. Every line explained, ranked by what matters, with the fix for each.

Wells in Hamilton County

850 domestic wells in Hamilton County are on record with the state. the typical well is 300 feet deep (one in ten goes past 482 feet).

Find your own well's report

The state keeps the driller's report for most wells drilled since 1984. It tells you how deep your well is, where bedrock starts, and how much water it makes, which decides what treatment can work.

  1. Open NYSDEC water well completion reports and choose Water Well.
  2. The report lists depth, depth to bedrock, cased depth, yield and the driller.

Drillers have filed reports with the state since April 2000; a well drilled before then usually has no record.

The rock under Hamilton County

Not a principal aquifer

The USGS map places this area outside any principal aquifer, which usually means wells here draw from fractured bedrock or thin local deposits rather than a large regional aquifer. Bedrock wells of that kind are where arsenic, radon and uranium turn up, and yields vary from well to well.

Classification from the USGS Principal Aquifers of the United States (national map, 2003 edition, GIS release 2015), read at the county centroid. A single well can sit in a different unit, especially near a boundary.

Official help in New York

Two places to start that are not selling anything: the state program that answers private well questions, and its list of labs certified to run drinking water tests. A certified lab is the difference between a result you can act on and a number.

Treatment that fits the local profile

Uranium

Point-of-use reverse osmosis; Anion exchange; Whole-house anion exchange

Nitrate

Point-of-use reverse osmosis; Anion exchange; Distillation

Manganese

Oxidizing filter (greensand, birm) whole-house; Water softener (low levels); Point-of-use reverse osmosis

Systems we would look at first

Some links below are affiliate links. If you buy through one, the merchant pays us a commission at no extra cost to you. It does not change which products we list or what the data says.

For uranium

Under-sink reverse osmosis system

under-sink or countertop, about $300

Look for NSF/ANSI 58 certification listing the contaminant you need removed.

For uranium

Whole-house arsenic and uranium filter

whole-house, at the point of entry, about $2,500

Adsorptive iron-based media; sized to your well yield.

For nitrate

Aquasana SmartFlow reverse osmosis

under-sink or countertop, about $225

Certified to NSF/ANSI 58 and 53 to reduce arsenic (96%, pentavalent), fluoride (90%), lead (99%), nitrate, nitrite and PFOA/PFOS at the kitchen tap, with a remineralizer.

For manganese

Iron and manganese oxidizing filter

whole-house, at the point of entry, about $1,800

Air-injection or greensand media; fixes staining at the source.

Free, no obligation

Get on the list for a free in-home water test in Hamilton County

No water treatment company serves Hamilton County through Well Water Nerd yet. We are signing licensed companies on county by county: they test at your tap for free, walk you through the numbers, and quote treatment only if something needs fixing. Leave your details and you are first in line. Nothing is shared until a company joins for Hamilton County, and you get an email naming it first.

What are you worried about?

The test is free and there is no obligation. No company is named yet; your details stay with us until one joins for your area, and we log the time and address of this request.

Common questions

How deep are wells in Hamilton County?

The typical domestic well in Hamilton County is 300 feet deep, based on 850 wells reported to the state. One in ten is deeper than 482 feet.

Is there arsenic in well water in Hamilton County?

Arsenic was detected in 41% of 17 public well samples in Hamilton County, and 0% were above the EPA limit of 10 ug/L. Arsenic has no taste or smell; a lab test is the only way to know your level.

How high is radon in well water in Hamilton County?

The median radon level across 17 public samples in Hamilton County was 990 pCi/L, with a high of 18,800 pCi/L. New Hampshire recommends treatment above 2,000 pCi/L.

How often should I test a private well in Hamilton County?

Test for bacteria and nitrate every year. Test once for arsenic, uranium, radon, fluoride, manganese and PFAS, then again every three to five years or after any change in taste, color, or plumbing.

Towns in Hamilton County

8 towns have fewer than 30 public samples and are included in the Hamilton County totals above rather than shown separately: Arietta, Benson, Hope, Indian Lake, Inlet, Lake Pleasant, Morehouse, Wells.

Counties near Hamilton County

Closest first. Groundwater does not stop at a line on a map, so the next county over is a fair second opinion.

Want the numbers themselves? Download the New York dataset as CSV, every county and town, with the sources named.

Sources

  • USGS Water Quality Portal: 494 samples in Hamilton County. Data from the Water Quality Portal, a service of USGS, EPA and USDA; groundwater samples collected by USGS and cooperators. Retrieved September 3, 2026.
  • USGS national arsenic model (Ayotte 2017): estimated share of 2,236 people on private wells in Hamilton County above 10 ug/L of arsenic, from geology, well depth and land use. County estimates of domestic well users with arsenic above 10 ug/L from the USGS national logistic regression model (Ayotte, Medalie and Qi, 2017), with private well population from the USGS 2015 county water-use compilation (Dieter and others, 2018). Retrieved September 15, 2026.
  • NYSDEC water well completion reports: 857 well records in Hamilton County, 850 domestic. Water well completion reports filed with the New York State Department of Environmental Conservation Water Well Contractor Program since 2000. Only aggregates are shown; owner names and addresses are never stored. Retrieved September 16, 2026.

Non-detects count as samples and are treated as zero when computing medians. Exactly at the limit counts as not above it. A sample belongs to the town containing the well's reported coordinates.