Well Water Nerd

Well water in Sheridan County, Nebraska

In Sheridan County, 14% of 193 tested well samples exceeded the EPA limit for nitrate (10 mg/L), based on public data from Nebraska Groundwater Quality Clearinghouse and USGS Water Quality Portal.

193 individual samples from 166 wells, 1953 to 2024. Data refreshed September 9, 2026.

What individual samples found

Each row summarizes every public sample for that contaminant inside Sheridan County. Above limit means above the EPA maximum contaminant level; where EPA has no enforceable limit, the row shows a health guideline or nuisance level instead.

ContaminantSamplesDetectedAbove limitMedianHighestLimit
Nitrate
1979 to 2024
19397%14%2.3645.310 mg/L
EPA limit

Sampled fewer than 10 times, too few to summarize: Uranium (6), Fluoride (2), Arsenic (1), Radon (6), Manganese (3), Chloride (2).

Get the free Sheridan County well report

One email with the numbers above, what they mean for a home in Sheridan County, exactly which tests to order, and what treatment fits the local profile. No spam, unsubscribe in one click.

What this means

The contaminants most often above their limit here are nitrate (14% of 193 samples). A well next door can differ sharply from yours because bedrock fractures, well depth and plumbing all matter, so these rates describe the area, not your tap.

Manganese and Chloride are widespread in local groundwater. They are mainly a staining and taste problem, but high manganese also carries a health advisory for infants.

What to test for in Sheridan County

  • Nitrate14% of 193 local samples were above the limit.
  • Coliform bacteriaRecommended for every private well, every year.
  • RadonMedian local reading is 330 pCi/L.
  • UraniumAbove the limit in 2 of 6 local samples; too few to quote a rate.
  • FluorideDetected in 100% of local samples.
  • ChlorideDetected in 100% of local samples.
  • ManganeseDetected in 67% of local samples.

Treatment that fits the local profile

Nitrate
Point-of-use reverse osmosis; Anion exchange; Distillation
Fluoride
Point-of-use reverse osmosis; Activated alumina; Distillation
Manganese
Oxidizing filter (greensand, birm) whole-house; Water softener (low levels); Point-of-use reverse osmosis
Chloride
Point-of-use reverse osmosis; Distillation

Get your Sheridan County water tested at home

A licensed local water treatment company tests your tap water in your home, walks you through the numbers, and quotes treatment only if something needs fixing. Free, about 30 minutes, no obligation. Tell us what you need and we match you with a company that serves Sheridan County.

What are you worried about?

The test is free and there is no obligation. Your details go only to the company named above, and we log the time and address of this request.

Common questions

Is there arsenic in well water in Sheridan County?

Arsenic was detected in 100% of 1 public well samples in Sheridan County, and 0% were above the EPA limit of 10 ug/L. Arsenic has no taste or smell; a lab test is the only way to know your level.

How high is radon in well water in Sheridan County?

The median radon level across 6 public samples in Sheridan County was 330 pCi/L, with a high of 510 pCi/L. New Hampshire recommends treatment above 2,000 pCi/L.

How often should I test a private well in Sheridan County?

Test for bacteria and nitrate every year. Test once for arsenic, uranium, radon, fluoride, manganese and PFAS, then again every three to five years or after any change in taste, color, or plumbing.

Sources

  • Nebraska Groundwater Quality Clearinghouse: 193 samples in Sheridan County. Groundwater quality results compiled by the Nebraska Department of Environment and Energy, University of Nebraska and Nebraska Department of Agriculture in the Groundwater Quality Clearinghouse, contributed by Natural Resources Districts and state agencies. Retrieved September 9, 2026.
  • USGS Water Quality Portal: 20 samples in Sheridan County. Data from the Water Quality Portal, a service of USGS, EPA and USDA; groundwater samples collected by USGS and cooperators. Retrieved September 3, 2026.

Non-detects count as samples and are treated as zero when computing medians. Exactly at the limit counts as not above it. A sample belongs to the town containing the well's reported coordinates.