Well Water Nerd

Well water in Cuming County, Nebraska

In Cuming County, 16% of 158 tested well samples exceeded the EPA limit for nitrate (10 mg/L), based on public data from Nebraska Groundwater Quality Clearinghouse and USGS Water Quality Portal.

158 individual samples from 87 wells, 1965 to 2026. Data refreshed September 9, 2026.

What individual samples found

Each row summarizes every public sample for that contaminant inside Cuming County. Above limit means above the EPA maximum contaminant level; where EPA has no enforceable limit, the row shows a health guideline or nuisance level instead.

ContaminantSamplesDetectedAbove limitMedianHighestLimit
Nitrate
1979 to 2024
15858%16%0.512610 mg/L
EPA limit
Uranium
2003 to 2026
1894%0%11.22830 ug/L
EPA limit

Sampled fewer than 10 times, too few to summarize: Radium (226 + 228) (8), Fluoride (3), Arsenic (1), Iron (4), Sodium (4), Manganese (2), Radon (1).

Get the free Cuming County well report

One email with the numbers above, what they mean for a home in Cuming County, exactly which tests to order, and what treatment fits the local profile. No spam, unsubscribe in one click.

What this means

The contaminants most often above their limit here are nitrate (16% of 158 samples). A well next door can differ sharply from yours because bedrock fractures, well depth and plumbing all matter, so these rates describe the area, not your tap.

Iron and Manganese are widespread in local groundwater. They are mainly a staining and taste problem, but high manganese also carries a health advisory for infants.

What to test for in Cuming County

  • Nitrate16% of 158 local samples were above the limit.
  • Coliform bacteriaRecommended for every private well, every year.
  • RadonMedian local reading is 200 pCi/L.
  • FluorideDetected in 100% of local samples.
  • ManganeseDetected in 100% of local samples.
  • IronDetected in 75% of local samples.

Treatment that fits the local profile

Nitrate
Point-of-use reverse osmosis; Anion exchange; Distillation
Fluoride
Point-of-use reverse osmosis; Activated alumina; Distillation
Iron
Oxidizing filter whole-house; Water softener (low levels); Aeration plus filtration
Manganese
Oxidizing filter (greensand, birm) whole-house; Water softener (low levels); Point-of-use reverse osmosis

Get your Cuming County water tested at home

A licensed local water treatment company tests your tap water in your home, walks you through the numbers, and quotes treatment only if something needs fixing. Free, about 30 minutes, no obligation. Tell us what you need and we match you with a company that serves Cuming County.

What are you worried about?

The test is free and there is no obligation. Your details go only to the company named above, and we log the time and address of this request.

Common questions

Is there arsenic in well water in Cuming County?

Arsenic was detected in 100% of 1 public well samples in Cuming County, and 0% were above the EPA limit of 10 ug/L. Arsenic has no taste or smell; a lab test is the only way to know your level.

How high is radon in well water in Cuming County?

The median radon level across 1 public samples in Cuming County was 200 pCi/L, with a high of 200 pCi/L. New Hampshire recommends treatment above 2,000 pCi/L.

How often should I test a private well in Cuming County?

Test for bacteria and nitrate every year. Test once for arsenic, uranium, radon, fluoride, manganese and PFAS, then again every three to five years or after any change in taste, color, or plumbing.

Sources

  • Nebraska Groundwater Quality Clearinghouse: 155 samples in Cuming County. Groundwater quality results compiled by the Nebraska Department of Environment and Energy, University of Nebraska and Nebraska Department of Agriculture in the Groundwater Quality Clearinghouse, contributed by Natural Resources Districts and state agencies. Retrieved September 9, 2026.
  • USGS Water Quality Portal: 44 samples in Cuming County. Data from the Water Quality Portal, a service of USGS, EPA and USDA; groundwater samples collected by USGS and cooperators. Retrieved September 3, 2026.

Non-detects count as samples and are treated as zero when computing medians. Exactly at the limit counts as not above it. A sample belongs to the town containing the well's reported coordinates.