Well Water Nerd

Well water in Boone County, Nebraska

1in12

Testing recommended

tested well samples in Boone County exceeded the EPA limit for nitrate (10 mg/L), based on public data from Nebraska Groundwater Quality Clearinghouse and USGS Water Quality Portal.

603 test results across 9 contaminants from at least 167 wells, 1959 to 2025; nitrate has the most at 502. Data refreshed September 15, 2026.

Compiled by Nick at Well Water Nerd from public records. How these pages are built

An estimated 2,175 people in Boone County get their drinking water from a private well, per USGS 2015 county water use. That is about 41% of residents.

Separately, the USGS national arsenic model estimates that 7% of the 2,175 people on private wells in Boone County draw water above 10 ug/L (the model's range is 5% to 9%), from geology and well depth rather than local tests.

What individual samples found

Each row summarizes every public sample for that contaminant inside Boone County. Above limit means above the EPA maximum contaminant level; where EPA has no enforceable limit, the row shows a health guideline or nuisance level instead.

ContaminantAbove limitSamplesDetectedMedianHighestLimit
Nitrate
1959 to 2025
50292%1.617310 mg/L
EPA limit
Fluoride
1959 to 2002
27100%0.30.54 mg/L
EPA limit
Chloride
1959 to 2002
no limit27100%210250 mg/L
nuisance level
Sodium
1959 to 2002
no limit27100%91720 mg/L
health guideline

Sampled fewer than 10 times, too few to summarize: Arsenic (3), Uranium (1), Iron (9), Manganese (6), Radon (1).

Over time

Share of samples above the limit by period. A cell needs ten samples to show; a comparison needs twenty in each period. Later periods sample fewer wells, and often the ones already known to have a problem.

Contaminantbefore 20002000s2010s2020s
Nitrate4%135 samples7%135 samples14%150 samples7%82 samples

Nitrate above the limit in Boone County fell from 14% of 150 samples in the 2010s to 7% of 82 in the 2020s.

Closer than the county

See the sampled wells near your address

The same records, drawn around one point: which wells within a few miles were sampled and what they found, how deep the wells next to you were drilled, and any leaking tank or cleanup site within a mile.

Check my address

What this means

The contaminants most often above their limit here are nitrate (8% of 502 samples). A well next door can differ sharply from yours because bedrock fractures, well depth and plumbing all matter, so these rates describe the area, not your tap.

Chloride and Iron are widespread in local groundwater. They are mainly a staining and taste problem, but high manganese also carries a health advisory for infants.

What to test for in Boone County

  1. 1
    Nitrate
    8% of 502 local samples were above the limit.
  2. 2
    Coliform bacteria
    Recommended for every private well, every year.
  3. 3
    Radon
    Median local reading is 210 pCi/L.
  4. 4
    Arsenic
    Above the limit in 1 of 3 local samples; too few to quote a rate.
  5. 5
    Fluoride
    Detected in 100% of local samples.
  6. 6
    Chloride
    Detected in 100% of local samples.
  7. 7
    Iron
    Detected in 89% of local samples.

Test your Boone County well for nitrate, coliform bacteria and radon

Certified lab analysis of your own tap water, bottles and prepaid return shipping included. The Essential well panel covers arsenic, uranium, nitrate, lead, copper, manganese, iron, sodium and bacteria; radon and PFAS are add-ons.

Order the Tap Score well water test kit, from $209Already tested? Upload the report

Just want bacteria checked first? Tap Score coliform and E. coli test, $99. Coliform and E. coli are the tests every well needs every year.

Want a quick look before paying for a lab? Home well water test strips on Amazon check hardness, iron, pH and nitrate in minutes. They are a screen, not a result: arsenic, bacteria, uranium and PFAS need a certified lab.

Affiliate links: the merchant pays us a commission and the price is the same for you. It does not change what the data above says. As an Amazon Associate we earn from qualifying purchases.

Where to get a well tested in Nebraska: certified labs, state programs and prices.

Already have results back? Get your lab report read against the Boone County numbers, $29. Every line explained, ranked by what matters, with the fix for each.

The rock under Boone County

High Plains aquifer

Unconsolidated sand and gravel. Wells in sand and gravel are usually shallow and productive, and they recharge quickly from the surface. That makes them the most exposed to nitrate, bacteria and anything spilled nearby, and the least likely to carry arsenic or radon from the rock.

Classification from the USGS Principal Aquifers of the United States (national map, 2003 edition, GIS release 2015), read at the county centroid. A single well can sit in a different unit, especially near a boundary.

Official help in Nebraska

Two places to start that are not selling anything: the state program that answers private well questions, and its list of labs certified to run drinking water tests. A certified lab is the difference between a result you can act on and a number.

Treatment that fits the local profile

Nitrate

Point-of-use reverse osmosis; Anion exchange; Distillation

Systems we would look at first

Some links below are affiliate links. If you buy through one, the merchant pays us a commission at no extra cost to you. It does not change which products we list or what the data says.

For nitrate

Under-sink reverse osmosis system

under-sink or countertop, about $300

Look for NSF/ANSI 58 certification listing the contaminant you need removed.

For nitrate

Aquasana SmartFlow reverse osmosis

under-sink or countertop, about $225

Certified to NSF/ANSI 58 and 53 to reduce arsenic (96%, pentavalent), fluoride (90%), lead (99%), nitrate, nitrite and PFOA/PFOS at the kitchen tap, with a remineralizer.

Free, no obligation

Get on the list for a free in-home water test in Boone County

No water treatment company serves Boone County through Well Water Nerd yet. We are signing licensed companies on county by county: they test at your tap for free, walk you through the numbers, and quote treatment only if something needs fixing. Leave your details and you are first in line. Nothing is shared until a company joins for Boone County, and you get an email naming it first.

What are you worried about?

The test is free and there is no obligation. No company is named yet; your details stay with us until one joins for your area, and we log the time and address of this request.

Common questions

How often should I test a private well in Boone County?

Test for bacteria and nitrate every year. Test once for arsenic, uranium, radon, fluoride, manganese and PFAS, then again every three to five years or after any change in taste, color, or plumbing.

Counties near Boone County

Closest first. Groundwater does not stop at a line on a map, so the next county over is a fair second opinion.

Want the numbers themselves? Download the Nebraska dataset as CSV, every county and town, with the sources named.

Sources

  • Nebraska Groundwater Quality Clearinghouse: 445 samples in Boone County. Groundwater quality results compiled by the Nebraska Department of Environment and Energy, University of Nebraska and Nebraska Department of Agriculture in the Groundwater Quality Clearinghouse, contributed by Natural Resources Districts and state agencies. Retrieved September 9, 2026.
  • USGS Water Quality Portal: 158 samples in Boone County. Data from the Water Quality Portal, a service of USGS, EPA and USDA; groundwater samples collected by USGS and cooperators. Retrieved September 3, 2026.
  • USGS national arsenic model (Ayotte 2017): estimated share of 2,175 people on private wells in Boone County above 10 ug/L of arsenic, from geology, well depth and land use. County estimates of domestic well users with arsenic above 10 ug/L from the USGS national logistic regression model (Ayotte, Medalie and Qi, 2017), with private well population from the USGS 2015 county water-use compilation (Dieter and others, 2018). Retrieved September 15, 2026.

Non-detects count as samples and are treated as zero when computing medians. Exactly at the limit counts as not above it. A sample belongs to the town containing the well's reported coordinates.