Well Water Nerd

Well water in Gallatin County, Montana

1in2

Testing strongly recommended

tested well samples in Gallatin County exceeded the EPA limit for arsenic (10 ug/L), based on public data from USGS Water Quality Portal.

2,990 test results across 11 contaminants from at least 488 wells, 1951 to 2023; chloride has the most at 566. Data refreshed September 15, 2026.

Compiled by Nick at Well Water Nerd from public records. How these pages are built

An estimated 24,285 people in Gallatin County get their drinking water from a private well, per USGS 2015 county water use. That is about 24% of residents.

Separately, the USGS national arsenic model estimates that 6% of the 24,285 people on private wells in Gallatin County draw water above 10 ug/L (the model's range is 4% to 8%), from geology and well depth rather than local tests.

What individual samples found

Each row summarizes every public sample for that contaminant inside Gallatin County. Above limit means above the EPA maximum contaminant level; where EPA has no enforceable limit, the row shows a health guideline or nuisance level instead.

ContaminantAbove limitSamplesDetectedMedianHighestLimit
Arsenic
1979 to 2016
22984%12.817610 ug/L
EPA limit
Nitrate
1951 to 2022
45294%1.0911010 mg/L
EPA limit
Fluoride
1951 to 2010
26294%0.3184 mg/L
EPA limit
Copper
1983 to 1994
11047%00.041.3 mg/L
EPA limit
Lead
1983 to 1994
1042%01015 ug/L
EPA limit
Chloride
1951 to 2023
no limit56699%6336250 mg/L
nuisance level
Sodium
1951 to 2013
no limit467100%1342120 mg/L
health guideline
Iron
1951 to 2016
no limit41439%011,000300 ug/L
nuisance level
Manganese
1979 to 2013
no limit36119%03,030300 ug/L
health guideline
Radon
1993
no limit16100%6241,5602,000 pCi/L
health guideline

Sampled fewer than 10 times, too few to summarize: E. coli (9).

Over time

Share of samples above the limit by period. A cell needs ten samples to show; a comparison needs twenty in each period. Later periods sample fewer wells, and often the ones already known to have a problem.

Contaminantbefore 20002000s2010s2020s
Nitrate4%427 samplesn/a0%16 samplesn/a
Arsenic52%204 samplesn/a52%25 samplesn/a

Arsenic has held within a few points between the two most recent periods with enough samples.

Closer than the county

See the sampled wells near your address

The same records, drawn around one point: which wells within a few miles were sampled and what they found, how deep the wells next to you were drilled, and any leaking tank or cleanup site within a mile.

Check my address

What this means

The contaminants most often above their limit here are arsenic (52% of 229 samples), nitrate (4% of 452 samples), and fluoride (2% of 262 samples). A well next door can differ sharply from yours because bedrock fractures, well depth and plumbing all matter, so these rates describe the area, not your tap.

Chloride is widespread in local groundwater. It is mainly a staining and taste problem, but high manganese also carries a health advisory for infants.

What to test for in Gallatin County

  1. 1
    Arsenic
    52% of 229 local samples were above the limit.
  2. 2
    Nitrate
    4% of 452 local samples were above the limit.
  3. 3
    Fluoride
    2% of 262 local samples were above the limit.
  4. 4
    Coliform bacteria
    Recommended for every private well, every year.
  5. 5
    Radon
    Median local reading is 624 pCi/L.
  6. 6
    Chloride
    Detected in 99% of local samples.
  7. 7
    Volatile organic compounds (VOCs)
    230 leaking underground storage tank sites on record locally.

Test your Gallatin County well for arsenic, nitrate and fluoride

Certified lab analysis of your own tap water, bottles and prepaid return shipping included. The Essential well panel covers arsenic, uranium, nitrate, lead, copper, manganese, iron, sodium and bacteria; radon and PFAS are add-ons.

Order the Tap Score well water test kit, from $209Already tested? Upload the report

Just want bacteria checked first? Tap Score coliform and E. coli test, $99. Coliform and E. coli are the tests every well needs every year.

Want a quick look before paying for a lab? Home well water test strips on Amazon check hardness, iron, pH and nitrate in minutes. They are a screen, not a result: arsenic, bacteria, uranium and PFAS need a certified lab.

Affiliate links: the merchant pays us a commission and the price is the same for you. It does not change what the data above says. As an Amazon Associate we earn from qualifying purchases.

Where to get a well tested in Montana: certified labs, state programs and prices.

Already have results back? Get your lab report read against the Gallatin County numbers, $29. Every line explained, ranked by what matters, with the fix for each.

The rock under Gallatin County

Not a principal aquifer

The USGS map places this area outside any principal aquifer, which usually means wells here draw from fractured bedrock or thin local deposits rather than a large regional aquifer. Bedrock wells of that kind are where arsenic, radon and uranium turn up, and yields vary from well to well.

Classification from the USGS Principal Aquifers of the United States (national map, 2003 edition, GIS release 2015), read at the county centroid. A single well can sit in a different unit, especially near a boundary.

Official help in Montana

Two places to start that are not selling anything: the state program that answers private well questions, and its list of labs certified to run drinking water tests. A certified lab is the difference between a result you can act on and a number.

Contamination sources on record in Gallatin County

Montana DEQ records 230 leaking underground storage tank sites in Gallatin County, among 338 regulated sites in total. Groundwater does not follow property lines, so a well within a few hundred feet of one of these is worth testing for what that site could release.

230
leaking underground storage tank sitesGasoline and heating oil that leaked from tanks move through groundwater as benzene, MTBE and other volatile organic compounds.
87
registered underground storage tank sitesRegistered tanks are regulated and inspected; they matter most when they are old or near a shallow well.
4
lined landfills and transfer facilities
17
other solid waste facilities

Treatment that fits the local profile

Arsenic

Point-of-use reverse osmosis; Adsorptive media (iron-based) whole-house; Anion exchange

Nitrate

Point-of-use reverse osmosis; Anion exchange; Distillation

Fluoride

Point-of-use reverse osmosis; Activated alumina; Distillation

Systems we would look at first

Some links below are affiliate links. If you buy through one, the merchant pays us a commission at no extra cost to you. It does not change which products we list or what the data says.

For arsenic

Under-sink reverse osmosis system

under-sink or countertop, about $300

Look for NSF/ANSI 58 certification listing the contaminant you need removed.

For arsenic

Whole-house arsenic and uranium filter

whole-house, at the point of entry, about $2,500

Adsorptive iron-based media; sized to your well yield.

For arsenic

Aquasana SmartFlow reverse osmosis

under-sink or countertop, about $225

Certified to NSF/ANSI 58 and 53 to reduce arsenic (96%, pentavalent), fluoride (90%), lead (99%), nitrate, nitrite and PFOA/PFOS at the kitchen tap, with a remineralizer.

Free, no obligation

Get on the list for a free in-home water test in Gallatin County

No water treatment company serves Gallatin County through Well Water Nerd yet. We are signing licensed companies on county by county: they test at your tap for free, walk you through the numbers, and quote treatment only if something needs fixing. Leave your details and you are first in line. Nothing is shared until a company joins for Gallatin County, and you get an email naming it first.

What are you worried about?

The test is free and there is no obligation. No company is named yet; your details stay with us until one joins for your area, and we log the time and address of this request.

Common questions

Is there arsenic in well water in Gallatin County?

Arsenic was detected in 84% of 229 public well samples in Gallatin County, and 52% were above the EPA limit of 10 ug/L. Arsenic has no taste or smell; a lab test is the only way to know your level.

How high is radon in well water in Gallatin County?

The median radon level across 16 public samples in Gallatin County was 624 pCi/L, with a high of 1,560 pCi/L. New Hampshire recommends treatment above 2,000 pCi/L.

How often should I test a private well in Gallatin County?

Test for bacteria and nitrate every year. Test once for arsenic, uranium, radon, fluoride, manganese and PFAS, then again every three to five years or after any change in taste, color, or plumbing.

Counties near Gallatin County

Closest first. Groundwater does not stop at a line on a map, so the next county over is a fair second opinion.

Want the numbers themselves? Download the Montana dataset as CSV, every county and town, with the sources named.

Sources

  • USGS Water Quality Portal: 2,990 samples in Gallatin County. Data from the Water Quality Portal, a service of USGS, EPA and USDA; groundwater samples collected by USGS and cooperators. Retrieved September 3, 2026.
  • USGS national arsenic model (Ayotte 2017): estimated share of 24,285 people on private wells in Gallatin County above 10 ug/L of arsenic, from geology, well depth and land use. County estimates of domestic well users with arsenic above 10 ug/L from the USGS national logistic regression model (Ayotte, Medalie and Qi, 2017), with private well population from the USGS 2015 county water-use compilation (Dieter and others, 2018). Retrieved September 15, 2026.
  • Montana DEQ regulated sites: 338 regulated sites located in Gallatin County. Petroleum tank releases, underground storage tank facilities and licensed solid waste facilities from the Montana Department of Environmental Quality. Retrieved September 18, 2026.

Non-detects count as samples and are treated as zero when computing medians. Exactly at the limit counts as not above it. A sample belongs to the town containing the well's reported coordinates.