Well Water Nerd

Well water in Marion township, Minnesota

In Marion township, chloride was detected in 97% of 31 tested well samples from USGS Water Quality Portal.

The strongest signal is coliform bacteria: Recommended for every private well, every year, too few samples to carry the headline but first on the test list below.

162 test results across 10 contaminants from at least 7 wells, 1963 to 2025; chloride has the most at 31. Data refreshed September 3, 2026.

Compiled by Nick at Well Water Nerd from public records. How these pages are built

What individual samples found

Each row summarizes every public sample for that contaminant inside Marion township. Above limit means above the EPA maximum contaminant level; where EPA has no enforceable limit, the row shows a health guideline or nuisance level instead.

ContaminantAbove limitSamplesDetectedMedianHighestLimit
Arsenic
2010 to 2025
176%00.12810 ug/L
EPA limit
Lead
2010 to 2025
1712%03.5915 ug/L
EPA limit
Copper
2010 to 2025
1520%00.0221.3 mg/L
EPA limit
Fluoride
1963 to 2025
1233%00.34 mg/L
EPA limit
Chloride
1963 to 2025
no limit3197%2280.4250 mg/L
nuisance level
Iron
1963 to 2025
no limit2365%10151,000300 ug/L
nuisance level
Sodium
1963 to 2025
no limit20100%6.5715420 mg/L
health guideline
Manganese
1963 to 2025
no limit2065%19.9609300 ug/L
health guideline

Sampled fewer than 10 times, too few to summarize: PFOA (4), Nitrate (3).

Closer than the town

See the sampled wells near your address

The same records, drawn around one point: which wells within a few miles were sampled and what they found, how deep the wells next to you were drilled, and any leaking tank or cleanup site within a mile.

Check my address

What this means

Among contaminants with a federal limit, no tested sample in Marion township came back above it. That is reassuring, but sampling is uneven: wells that were never tested are not in this data.

Chloride, Iron, and Manganese are widespread in local groundwater. They are mainly a staining and taste problem, but high manganese also carries a health advisory for infants.

What to test for in Marion township

  1. 1
    Coliform bacteria
    Recommended for every private well, every year.
  2. 2
    Nitrate
    Recommended for every private well, especially near farms or septic systems.
  3. 3
    Chloride
    Detected in 97% of local samples.
  4. 4
    Iron
    Detected in 65% of local samples.
  5. 5
    Manganese
    Detected in 65% of local samples.
  6. 6
    Volatile organic compounds (VOCs)
    9 leaking underground storage tank sites on record locally.

Test your Marion township well for coliform bacteria, nitrate and chloride

Certified lab analysis of your own tap water, bottles and prepaid return shipping included. The Essential well panel covers arsenic, uranium, nitrate, lead, copper, manganese, iron, sodium and bacteria; radon and PFAS are add-ons.

Order the Tap Score well water test kit, from $209Already tested? Upload the report

Just want bacteria checked first? Tap Score coliform and E. coli test, $99. Coliform and E. coli are the tests every well needs every year.

Want a quick look before paying for a lab? Home well water test strips on Amazon check hardness, iron, pH and nitrate in minutes. They are a screen, not a result: arsenic, bacteria, uranium and PFAS need a certified lab.

Affiliate links: the merchant pays us a commission and the price is the same for you. It does not change what the data above says. As an Amazon Associate we earn from qualifying purchases.

Where to get a well tested in Minnesota: certified labs, state programs and prices.

Already have results back? Get your lab report read against the Marion township numbers, $29. Every line explained, ranked by what matters, with the fix for each.

Wells in Marion township

462 domestic wells in Marion township are on record with the state since 1952. 96% are drilled into bedrock, and the typical well is 297 feet deep (one in ten goes past 526 feet).

In a typical Marion township well, bedrock starts about 21 feet down.

Bedrock wells are where arsenic, uranium and radon come from: the water sits in fractures in granite and metamorphic rock and picks up whatever the rock carries. That is why testing for those three matters more here than in a dug or gravel well.

71
1960s
109
1970s
61
1980s
75
1990s
45
2000s
21
2010s
5
2020s

Find your own well's report

The state keeps the driller's report for most wells drilled since 1984. It tells you how deep your well is, where bedrock starts, and how much water it makes, which decides what treatment can work.

  1. Open Minnesota Well Index and choose Water Well.
  2. The record shows depth, casing, depth to bedrock, aquifer, static water level and the driller; new wells since 2008 also show the arsenic test result.

Wells drilled since 1974 have records; older wells appear only if a later owner reported them.

The rock under Marion township

Cambrian-Ordovician aquifer system

Sandstone. Sandstone wells draw from pore space in the rock and tend to be dependable. Iron, manganese and hardness are common, and some sandstones carry arsenic or radium, so a first test should include both.

Classification from the USGS Principal Aquifers of the United States (national map, 2003 edition, GIS release 2015), read at the town centroid. A single well can sit in a different unit, especially near a boundary.

Official help in Minnesota

Two places to start that are not selling anything: the state program that answers private well questions, and its list of labs certified to run drinking water tests. A certified lab is the difference between a result you can act on and a number.

Contamination sources on record in Marion township

MPCA records 9 leaking underground storage tank sites in Marion township, among 43 regulated sites in total. Groundwater does not follow property lines, so a well within a few hundred feet of one of these is worth testing for what that site could release.

9
leaking underground storage tank sitesGasoline and heating oil that leaked from tanks move through groundwater as benzene, MTBE and other volatile organic compounds.
24
registered underground storage tank sitesRegistered tanks are regulated and inspected; they matter most when they are old or near a shallow well.
9
lined landfills and transfer facilities
1
other remediation project

Treatment that fits the local profile

Iron

Oxidizing filter whole-house; Water softener (low levels); Aeration plus filtration

Manganese

Oxidizing filter (greensand, birm) whole-house; Water softener (low levels); Point-of-use reverse osmosis

Systems we would look at first

Some links below are affiliate links. If you buy through one, the merchant pays us a commission at no extra cost to you. It does not change which products we list or what the data says.

For iron

Iron and manganese oxidizing filter

whole-house, at the point of entry, about $1,800

Air-injection or greensand media; fixes staining at the source.

Free, no obligation

Get on the list for a free in-home water test in Marion township

No water treatment company serves Marion township through Well Water Nerd yet. We are signing licensed companies on county by county: they test at your tap for free, walk you through the numbers, and quote treatment only if something needs fixing. Leave your details and you are first in line. Nothing is shared until a company joins for Marion township, and you get an email naming it first.

What are you worried about?

The test is free and there is no obligation. No company is named yet; your details stay with us until one joins for your area, and we log the time and address of this request.

Common questions

How deep are wells in Marion township?

The typical domestic well in Marion township is 297 feet deep, based on 462 wells reported to the state since 1952. One in ten is deeper than 526 feet. 96% are drilled into bedrock.

Is there arsenic in well water in Marion township?

Arsenic was detected in 6% of 17 public well samples in Marion township, and 0% were above the EPA limit of 10 ug/L. Arsenic has no taste or smell; a lab test is the only way to know your level.

How often should I test a private well in Marion township?

Test for bacteria and nitrate every year. Test once for arsenic, uranium, radon, fluoride, manganese and PFAS, then again every three to five years or after any change in taste, color, or plumbing.

Towns near Marion township

Closest first. Groundwater does not stop at a line on a map, so the next town over is a fair second opinion.

Want the numbers themselves? Download the Minnesota dataset as CSV, every county and town, with the sources named.

Sources

  • USGS Water Quality Portal: 162 samples in Marion township. Data from the Water Quality Portal, a service of USGS, EPA and USDA; groundwater samples collected by USGS and cooperators. Retrieved September 3, 2026.
  • Minnesota Well Index: 722 well records in Marion township, 462 domestic. Well construction records from the Minnesota Well Index (Minnesota Department of Health), non-public-supply wells. Only aggregates are shown; owner names and addresses are never stored. Retrieved September 15, 2026.
  • MPCA regulated sites: 43 regulated sites located in Marion township. Tank, leak, remediation, Superfund and landfill sites from the Minnesota Pollution Control Agency What's In My Neighborhood database. Retrieved September 15, 2026.

Non-detects count as samples and are treated as zero when computing medians. Exactly at the limit counts as not above it. A sample belongs to the town containing the well's reported coordinates.