Well Water Nerd

Well water in Farmington, Minnesota

In Farmington, none of 55 tested well samples exceeded the EPA limit for copper, based on public data from USGS Water Quality Portal.

The strongest signal is coliform bacteria: Recommended for every private well, every year, too few samples to carry the headline but first on the test list below.

456 test results across 10 contaminants from at least 7 wells, 2005 to 2025; chloride has the most at 81. Data refreshed September 3, 2026.

Compiled by Nick at Well Water Nerd from public records. How these pages are built

What individual samples found

Each row summarizes every public sample for that contaminant inside Farmington. Above limit means above the EPA maximum contaminant level; where EPA has no enforceable limit, the row shows a health guideline or nuisance level instead.

ContaminantAbove limitSamplesDetectedMedianHighestLimit
Copper
2006 to 2025
5522%00.0031.3 mg/L
EPA limit
Lead
2006 to 2025
550%0015 ug/L
EPA limit
Arsenic
2006 to 2025
5547%01.5710 ug/L
EPA limit
Fluoride
2021 to 2025
150%004 mg/L
EPA limit
Nitrate
2006 to 2007
12100%2.51010 mg/L
EPA limit
Chloride
2005 to 2025
no limit8199%25298250 mg/L
nuisance level
Iron
2006 to 2025
no limit6751%03,000300 ug/L
nuisance level
Manganese
2006 to 2025
no limit5939%0641300 ug/L
health guideline
Sodium
2008 to 2025
no limit51100%12.711420 mg/L
health guideline

Sampled fewer than 10 times, too few to summarize: PFOA (6).

Over time

Share of samples above the limit by period. A cell needs ten samples to show; a comparison needs twenty in each period. Later periods sample fewer wells, and often the ones already known to have a problem.

Contaminantbefore 20002000s2010s2020s
Coppern/an/a0%29 samples0%18 samples
Leadn/an/a0%29 samples0%18 samples
Arsenicn/an/a0%29 samples0%18 samples

Closer than the town

See the sampled wells near your address

The same records, drawn around one point: which wells within a few miles were sampled and what they found, how deep the wells next to you were drilled, and any leaking tank or cleanup site within a mile.

Check my address

What this means

Among contaminants with a federal limit, no tested sample in Farmington came back above it. That is reassuring, but sampling is uneven: wells that were never tested are not in this data.

Chloride and Iron are widespread in local groundwater. They are mainly a staining and taste problem, but high manganese also carries a health advisory for infants.

What to test for in Farmington

  1. 1
    Coliform bacteria
    Recommended for every private well, every year.
  2. 2
    Nitrate
    Recommended for every private well, especially near farms or septic systems.
  3. 3
    Chloride
    Detected in 99% of local samples.
  4. 4
    Iron
    Detected in 51% of local samples.
  5. 5
    Volatile organic compounds (VOCs)
    33 leaking underground storage tank sites on record locally.
  6. 6
    Metals panel
    2 hazardous waste sites on record locally.

Test your Farmington well for coliform bacteria, nitrate and chloride

Certified lab analysis of your own tap water, bottles and prepaid return shipping included. The Essential well panel covers arsenic, uranium, nitrate, lead, copper, manganese, iron, sodium and bacteria; radon and PFAS are add-ons.

Order the Tap Score well water test kit, from $209Already tested? Upload the report

Just want bacteria checked first? Tap Score coliform and E. coli test, $99. Coliform and E. coli are the tests every well needs every year.

Want a quick look before paying for a lab? Home well water test strips on Amazon check hardness, iron, pH and nitrate in minutes. They are a screen, not a result: arsenic, bacteria, uranium and PFAS need a certified lab.

Affiliate links: the merchant pays us a commission and the price is the same for you. It does not change what the data above says. As an Amazon Associate we earn from qualifying purchases.

Where to get a well tested in Minnesota: certified labs, state programs and prices.

Already have results back? Get your lab report read against the Farmington numbers, $29. Every line explained, ranked by what matters, with the fix for each.

Wells in Farmington

67 domestic wells in Farmington are on record with the state since 1960. 86% are drilled into bedrock, and the typical well is 160 feet deep (one in ten goes past 220 feet).

In a typical Farmington well, bedrock starts about 124 feet down.

Bedrock wells are where arsenic, uranium and radon come from: the water sits in fractures in granite and metamorphic rock and picks up whatever the rock carries. That is why testing for those three matters more here than in a dug or gravel well.

11
1970s
13
1980s
14
1990s
9
2000s
5
2010s

Find your own well's report

The state keeps the driller's report for most wells drilled since 1984. It tells you how deep your well is, where bedrock starts, and how much water it makes, which decides what treatment can work.

  1. Open Minnesota Well Index and choose Water Well.
  2. The record shows depth, casing, depth to bedrock, aquifer, static water level and the driller; new wells since 2008 also show the arsenic test result.

Wells drilled since 1974 have records; older wells appear only if a later owner reported them.

The rock under Farmington

Cambrian-Ordovician aquifer system

Sandstone. Sandstone wells draw from pore space in the rock and tend to be dependable. Iron, manganese and hardness are common, and some sandstones carry arsenic or radium, so a first test should include both.

Classification from the USGS Principal Aquifers of the United States (national map, 2003 edition, GIS release 2015), read at the town centroid. A single well can sit in a different unit, especially near a boundary.

Official help in Minnesota

Two places to start that are not selling anything: the state program that answers private well questions, and its list of labs certified to run drinking water tests. A certified lab is the difference between a result you can act on and a number.

Contamination sources on record in Farmington

MPCA records 33 leaking underground storage tank sites and 2 hazardous waste sites in Farmington, among 78 regulated sites in total. Groundwater does not follow property lines, so a well within a few hundred feet of one of these is worth testing for what that site could release.

33
leaking underground storage tank sitesGasoline and heating oil that leaked from tanks move through groundwater as benzene, MTBE and other volatile organic compounds.
2
hazardous waste sitesSolvents, degreasers and metals from industrial sites can travel far in fractured bedrock.
28
registered underground storage tank sitesRegistered tanks are regulated and inspected; they matter most when they are old or near a shallow well.
1
lined landfill or transfer facility
14
other remediation projects

Treatment that fits the local profile

Iron

Oxidizing filter whole-house; Water softener (low levels); Aeration plus filtration

Manganese

Oxidizing filter (greensand, birm) whole-house; Water softener (low levels); Point-of-use reverse osmosis

Systems we would look at first

Some links below are affiliate links. If you buy through one, the merchant pays us a commission at no extra cost to you. It does not change which products we list or what the data says.

For iron

Iron and manganese oxidizing filter

whole-house, at the point of entry, about $1,800

Air-injection or greensand media; fixes staining at the source.

Free, no obligation

Get on the list for a free in-home water test in Farmington

No water treatment company serves Farmington through Well Water Nerd yet. We are signing licensed companies on county by county: they test at your tap for free, walk you through the numbers, and quote treatment only if something needs fixing. Leave your details and you are first in line. Nothing is shared until a company joins for Farmington, and you get an email naming it first.

What are you worried about?

The test is free and there is no obligation. No company is named yet; your details stay with us until one joins for your area, and we log the time and address of this request.

Common questions

How deep are wells in Farmington?

The typical domestic well in Farmington is 160 feet deep, based on 67 wells reported to the state since 1960. One in ten is deeper than 220 feet. 86% are drilled into bedrock.

Is there arsenic in well water in Farmington?

Arsenic was detected in 47% of 55 public well samples in Farmington, and 0% were above the EPA limit of 10 ug/L. Arsenic has no taste or smell; a lab test is the only way to know your level.

How often should I test a private well in Farmington?

Test for bacteria and nitrate every year. Test once for arsenic, uranium, radon, fluoride, manganese and PFAS, then again every three to five years or after any change in taste, color, or plumbing.

Towns near Farmington

Closest first. Groundwater does not stop at a line on a map, so the next town over is a fair second opinion.

Want the numbers themselves? Download the Minnesota dataset as CSV, every county and town, with the sources named.

Sources

  • USGS Water Quality Portal: 456 samples in Farmington. Data from the Water Quality Portal, a service of USGS, EPA and USDA; groundwater samples collected by USGS and cooperators. Retrieved September 3, 2026.
  • Minnesota Well Index: 169 well records in Farmington, 67 domestic. Well construction records from the Minnesota Well Index (Minnesota Department of Health), non-public-supply wells. Only aggregates are shown; owner names and addresses are never stored. Retrieved September 15, 2026.
  • MPCA regulated sites: 78 regulated sites located in Farmington. Tank, leak, remediation, Superfund and landfill sites from the Minnesota Pollution Control Agency What's In My Neighborhood database. Retrieved September 15, 2026.

Non-detects count as samples and are treated as zero when computing medians. Exactly at the limit counts as not above it. A sample belongs to the town containing the well's reported coordinates.