Well Water Nerd

Well water in Wilton, Maine

In Wilton, 1% of 88 private wells tested had fluoride above the Maine guideline (2 mg/L), according to Maine CDC.

93 private wells tested in state summaries; 3 individual samples from 3 wells, 2024. Data refreshed September 3, 2026.

Maine DEP samples private wells near fields where sludge or septage was spread and near other known PFAS sources, and resamples detections. PFAS shares describe wells that were tested for a reason, not every well in the area.

What homeowner tests found

Maine Tracking Network private well summaries: private wells tested and reported to the state. Shares are against the level the state applies to each contaminant, named in the last column; several are stricter than EPA.

ContaminantWells testedAbove state levelMedian95th pctHighestState level
Manganese771%300 ug/L
Fluoride881%2 mg/L
Nitrate930%10 mg/L
Nitrite930%1 mg/L
Arsenic800%10 ug/L
Uranium660%30 ug/L

Get the free Wilton well report

One email with the numbers above, what they mean for a home in Wilton, exactly which tests to order, and what treatment fits the local profile. No spam, unsubscribe in one click.

What this means

Among homeowners in Wilton who sent a sample to the state lab, the health-based limits most often exceeded were fluoride (1% of 88 wells). These are ordinary wells tested by their owners, so the shares are the best available picture of a typical well here, with one caveat: people test more often when they suspect a problem.

What to test for in Wilton

  • Volatile organic compounds (VOCs)1 leaking underground storage tank site on record locally.
  • PFAS2 unlined landfills on record locally.
  • Metals panel2 hazardous waste sites on record locally.
  • Manganese1% of 77 local wells tested were above the Maine guideline.
  • Fluoride1% of 88 local wells tested were above the Maine guideline.
  • Coliform bacteriaRecommended for every private well, every year.
  • NitrateRecommended for every private well, especially near farms or septic systems.

Wells in Wilton

260 domestic wells in Wilton are on record with the state since 1970. 99% are drilled into bedrock, and the typical well is 225 feet deep (one in ten goes past 400 feet).

In a typical Wilton well, bedrock starts about 50 feet down, the median yield is 6 gallons per minute, 15% of wells yield under 3 gallons per minute and usually need a storage tank.

Bedrock wells are where arsenic, uranium and radon come from: the water sits in fractures in granite and metamorphic rock and picks up whatever the rock carries. That is why testing for those three matters more here than in a dug or gravel well.

46
1970s
22
1980s
44
1990s
47
2000s
38
2010s
37
2020s

Contamination sources on record in Wilton

Maine DEP records 1 leaking underground storage tank site, 2 unlined landfills, and 2 hazardous waste sites in Wilton, among 10 regulated sites in total. Groundwater does not follow property lines, so a well within a few hundred feet of one of these is worth testing for what that site could release.

1
leaking underground storage tank siteGasoline and heating oil that leaked from tanks move through groundwater as benzene, MTBE and other volatile organic compounds.
2
unlined landfillsOlder unlined landfills are a leading source of PFAS, VOCs and metals in nearby wells.
2
hazardous waste sitesSolvents, degreasers and metals from industrial sites can travel far in fractured bedrock.
5
other remediation projects

Book a free water test in Wilton

A licensed local water treatment company tests your tap water in your home, walks you through the numbers, and quotes treatment only if something needs fixing. Free, about 30 minutes, no obligation.

What are you worried about?

The test is free and there is no obligation. Your details go only to the company named above, and we log the time and address of this request.

Common questions

How deep are wells in Wilton?

The typical domestic well in Wilton is 225 feet deep, based on 260 wells reported to the state since 1970. One in ten is deeper than 400 feet. 99% are drilled into bedrock.

How often should I test a private well in Wilton?

Test for bacteria and nitrate every year. Test once for arsenic, uranium, radon, fluoride, manganese and PFAS, then again every three to five years or after any change in taste, color, or plumbing.

Sources

  • Maine DEP PFAS investigation: 12 samples in Wilton. PFAS results for private wells sampled by the Maine Department of Environmental Protection. Retrieved September 3, 2026.
  • Maine Tracking Network private well summaries: summaries for 6 contaminants in Wilton, up to 93 wells each. Town summaries of private well tests run by the Maine Health and Environmental Testing Laboratory, published by Maine CDC through the Maine Tracking Network. Shares are against Maine's guideline for each analyte (arsenic 10 ug/L, uranium 30 ug/L, fluoride 2 mg/L, manganese 0.3 mg/L, nitrate 10 mg/L, nitrite 1 mg/L). Towns with too few tests are suppressed (NR). Only the share above the guideline and wells tested are published; no medians. Retrieved September 3, 2026.
  • Maine Geological Survey well database: 263 well records in Wilton, 260 domestic. Well construction records reported to the Maine Geological Survey by licensed well drillers. Only aggregates are shown; owner names and addresses are never stored. Retrieved September 3, 2026.
  • Maine DEP regulated sites: 10 regulated sites located in Wilton. Remediation sites, leaking underground storage tanks and closed municipal landfills from the Maine Department of Environmental Protection. Retrieved September 3, 2026.

Non-detects count as samples and are treated as zero when computing medians. Exactly at the limit counts as not above it. A sample belongs to the town containing the well's reported coordinates.