Well water in Appanoose County, Iowa
1in13
Testing recommended
tested well samples in Appanoose County exceeded the EPA limit for nitrate (10 mg/L), based on public data from USGS Water Quality Portal.
The strongest signal is radium (226 + 228): 70% of 10 local samples were above the limit, too few samples to carry the headline but first on the test list below.
236 test results across 11 contaminants from at least 19 wells, 1911 to 1979; nitrate has the most at 38. Data refreshed September 15, 2026.
Compiled by Nick at Well Water Nerd from public records. How these pages are built
An estimated 4,604 people in Appanoose County get their drinking water from a private well, per USGS 2015 county water use. That is about 37% of residents.
Separately, the USGS national arsenic model estimates that <1% of the 4,604 people on private wells in Appanoose County draw water above 10 ug/L (the model's range is <1% to 1%), from geology and well depth rather than local tests.
What individual samples found
Each row summarizes every public sample for that contaminant inside Appanoose County. Above limit means above the EPA maximum contaminant level; where EPA has no enforceable limit, the row shows a health guideline or nuisance level instead.
| Contaminant | Above limit | Samples | Detected | Median | Highest | Limit |
|---|---|---|---|---|---|---|
| Radium (226 + 228) 1974 to 1979 | 10 | 100% | 6.5 | 10 | 5 pCi/L EPA limit | |
| Nitrate 1935 to 1979 | 38 | 76% | 0.5 | 140 | 10 mg/L EPA limit | |
| Fluoride 1935 to 1979 | 38 | 100% | 2.8 | 4.1 | 4 mg/L EPA limit | |
| Copper 1971 to 1979 | 14 | 36% | 0 | 0.32 | 1.3 mg/L EPA limit | |
| Lead 1971 to 1979 | 14 | 50% | 0 | 0 | 15 ug/L EPA limit | |
| Arsenic 1971 to 1979 | 14 | 14% | 0 | 1 | 10 ug/L EPA limit | |
| Iron 1911 to 1979 | no limit | 38 | 97% | 990 | 15,000 | 300 ug/L nuisance level |
| Manganese 1935 to 1979 | no limit | 37 | 41% | 0 | 600 | 300 ug/L health guideline |
| Sodium 1957 to 1979 | no limit | 30 | 100% | 284 | 1,060 | 20 mg/L health guideline |
Sampled fewer than 10 times, too few to summarize: Uranium (2), Chloride (1).
Closer than the county
See the sampled wells near your address
The same records, drawn around one point: which wells within a few miles were sampled and what they found, how deep the wells next to you were drilled, and any leaking tank or cleanup site within a mile.
Check my addressWhat this means
The contaminants most often above their limit here are radium (226 + 228) (70% of 10 samples), nitrate (8% of 38 samples), and fluoride (3% of 38 samples). A well next door can differ sharply from yours because bedrock fractures, well depth and plumbing all matter, so these rates describe the area, not your tap.
Iron and Chloride are widespread in local groundwater. They are mainly a staining and taste problem, but high manganese also carries a health advisory for infants.
What to test for in Appanoose County
- 1Radium (226 + 228)70% of 10 local samples were above the limit.
- 2Nitrate8% of 38 local samples were above the limit.
- 3Fluoride3% of 38 local samples were above the limit.
- 4Coliform bacteriaRecommended for every private well, every year.
- 5ChlorideDetected in 100% of local samples.
- 6IronDetected in 97% of local samples.
- 7Volatile organic compounds (VOCs)40 leaking underground storage tank sites on record locally.
- 8Metals panel3 hazardous waste sites on record locally.
Test your Appanoose County well for radium (226 + 228), nitrate and fluoride
Certified lab analysis of your own tap water, bottles and prepaid return shipping included. The Essential well panel covers arsenic, uranium, nitrate, lead, copper, manganese, iron, sodium and bacteria; radon and PFAS are add-ons.
Order the Tap Score well water test kit, from $209Already tested? Upload the report
Just want bacteria checked first? Tap Score coliform and E. coli test, $99. Coliform and E. coli are the tests every well needs every year.
Want a quick look before paying for a lab? Home well water test strips on Amazon check hardness, iron, pH and nitrate in minutes. They are a screen, not a result: arsenic, bacteria, uranium and PFAS need a certified lab.
Affiliate links: the merchant pays us a commission and the price is the same for you. It does not change what the data above says. As an Amazon Associate we earn from qualifying purchases.
Where to get a well tested in Iowa: certified labs, state programs and prices.
Already have results back? Get your lab report read against the Appanoose County numbers, $29. Every line explained, ranked by what matters, with the fix for each.
The rock under Appanoose County
Not a principal aquifer
The USGS map places this area outside any principal aquifer, which usually means wells here draw from fractured bedrock or thin local deposits rather than a large regional aquifer. Bedrock wells of that kind are where arsenic, radon and uranium turn up, and yields vary from well to well.
Classification from the USGS Principal Aquifers of the United States (national map, 2003 edition, GIS release 2015), read at the county centroid. A single well can sit in a different unit, especially near a boundary.
Official help in Iowa
Two places to start that are not selling anything: the state program that answers private well questions, and its list of labs certified to run drinking water tests. A certified lab is the difference between a result you can act on and a number.
- Private Well Program, Iowa DNR
- LabCert - List of Certified Labs, Iowa DNR
Contamination sources on record in Appanoose County
Iowa DNR records 40 leaking underground storage tank sites and 3 hazardous waste sites in Appanoose County, among 62 regulated sites in total. Groundwater does not follow property lines, so a well within a few hundred feet of one of these is worth testing for what that site could release.
- 40
- leaking underground storage tank sitesGasoline and heating oil that leaked from tanks move through groundwater as benzene, MTBE and other volatile organic compounds.
- 3
- hazardous waste sitesSolvents, degreasers and metals from industrial sites can travel far in fractured bedrock.
- 1
- lined landfill or transfer facility
- 5
- other remediation projects
- 13
- other solid waste facilities
Treatment that fits the local profile
Radium (226 + 228)
Water softener (cation exchange); Point-of-use reverse osmosis
Nitrate
Point-of-use reverse osmosis; Anion exchange; Distillation
Fluoride
Point-of-use reverse osmosis; Activated alumina; Distillation
Iron
Oxidizing filter whole-house; Water softener (low levels); Aeration plus filtration
Manganese
Oxidizing filter (greensand, birm) whole-house; Water softener (low levels); Point-of-use reverse osmosis
Systems we would look at first
Some links below are affiliate links. If you buy through one, the merchant pays us a commission at no extra cost to you. It does not change which products we list or what the data says.
For radium (226 + 228)
Under-sink reverse osmosis system
under-sink or countertop, about $300
Look for NSF/ANSI 58 certification listing the contaminant you need removed.
For nitrate
Aquasana SmartFlow reverse osmosis
under-sink or countertop, about $225
Certified to NSF/ANSI 58 and 53 to reduce arsenic (96%, pentavalent), fluoride (90%), lead (99%), nitrate, nitrite and PFOA/PFOS at the kitchen tap, with a remineralizer.
For iron
Iron and manganese oxidizing filter
whole-house, at the point of entry, about $1,800
Air-injection or greensand media; fixes staining at the source.
Free, no obligation
Get on the list for a free in-home water test in Appanoose County
No water treatment company serves Appanoose County through Well Water Nerd yet. We are signing licensed companies on county by county: they test at your tap for free, walk you through the numbers, and quote treatment only if something needs fixing. Leave your details and you are first in line. Nothing is shared until a company joins for Appanoose County, and you get an email naming it first.
Common questions
Is there arsenic in well water in Appanoose County?
Arsenic was detected in 14% of 14 public well samples in Appanoose County, and 0% were above the EPA limit of 10 ug/L. Arsenic has no taste or smell; a lab test is the only way to know your level.
How often should I test a private well in Appanoose County?
Test for bacteria and nitrate every year. Test once for arsenic, uranium, radon, fluoride, manganese and PFAS, then again every three to five years or after any change in taste, color, or plumbing.
Counties near Appanoose County
Closest first. Groundwater does not stop at a line on a map, so the next county over is a fair second opinion.
Want the numbers themselves? Download the Iowa dataset as CSV, every county and town, with the sources named.
Sources
- USGS Water Quality Portal: 236 samples in Appanoose County. Data from the Water Quality Portal, a service of USGS, EPA and USDA; groundwater samples collected by USGS and cooperators. Retrieved September 3, 2026.
- USGS national arsenic model (Ayotte 2017): estimated share of 4,604 people on private wells in Appanoose County above 10 ug/L of arsenic, from geology, well depth and land use. County estimates of domestic well users with arsenic above 10 ug/L from the USGS national logistic regression model (Ayotte, Medalie and Qi, 2017), with private well population from the USGS 2015 county water-use compilation (Dieter and others, 2018). Retrieved September 15, 2026.
- Iowa DNR regulated sites: 62 regulated sites located in Appanoose County. Contaminated sites, solid waste facilities and leaking underground storage tank sites from the Iowa Department of Natural Resources. Retrieved September 18, 2026.
Non-detects count as samples and are treated as zero when computing medians. Exactly at the limit counts as not above it. A sample belongs to the town containing the well's reported coordinates.