Well water in Hancock County, Indiana
In Hancock County, 5% of 176 tested well samples exceeded the EPA limit for nitrate (10 mg/L), based on public data from USGS Water Quality Portal.
537 test results across 12 contaminants from at least 42 wells, 1955 to 2025; nitrate has the most at 176. Data refreshed September 15, 2026.
Compiled by Nick at Well Water Nerd from public records. How these pages are built
An estimated 42,642 people in Hancock County get their drinking water from a private well, per USGS 2015 county water use. That is about 59% of residents.
Separately, the USGS national arsenic model estimates that 12% of the 42,642 people on private wells in Hancock County draw water above 10 ug/L (the model's range is 9% to 15%), from geology and well depth rather than local tests.
What individual samples found
Each row summarizes every public sample for that contaminant inside Hancock County. Above limit means above the EPA maximum contaminant level; where EPA has no enforceable limit, the row shows a health guideline or nuisance level instead.
| Contaminant | Above limit | Samples | Detected | Median | Highest | Limit |
|---|---|---|---|---|---|---|
| Nitrate 1955 to 2025 | 176 | 35% | 0 | 45.1 | 10 mg/L EPA limit | |
| Fluoride 1955 to 2025 | 67 | 93% | 0.4 | 1.1 | 4 mg/L EPA limit | |
| Sodium 1955 to 2025 | no limit | 67 | 100% | 8.2 | 42 | 20 mg/L health guideline |
| Manganese 1955 to 2025 | no limit | 67 | 93% | 44 | 2,000 | 300 ug/L health guideline |
| Iron 1955 to 2025 | no limit | 67 | 76% | 1,000 | 7,800 | 300 ug/L nuisance level |
| Chloride 1955 to 2025 | no limit | 65 | 100% | 11.6 | 36.5 | 250 mg/L nuisance level |
Sampled fewer than 10 times, too few to summarize: Arsenic (8), Copper (6), Lead (6), Uranium (4), Radium (226 + 228) (2), Radon (2).
Over time
Share of samples above the limit by period. A cell needs ten samples to show; a comparison needs twenty in each period. Later periods sample fewer wells, and often the ones already known to have a problem.
| Contaminant | before 2000 | 2000s | 2010s | 2020s |
|---|---|---|---|---|
| Nitrate | 0%85 samples | 9%79 samples | n/a | 10%10 samples |
| Fluoride | 0%37 samples | 0%24 samples | n/a | n/a |
Nitrate above the limit in Hancock County rose from 0% of 85 samples before 2000 to 9% of 79 in the 2000s.
Fluoride has held within a few points between the two most recent periods with enough samples.
Closer than the county
See the sampled wells near your address
The same records, drawn around one point: which wells within a few miles were sampled and what they found, how deep the wells next to you were drilled, and any leaking tank or cleanup site within a mile.
Check my addressWhat this means
The contaminants most often above their limit here are nitrate (5% of 176 samples). A well next door can differ sharply from yours because bedrock fractures, well depth and plumbing all matter, so these rates describe the area, not your tap.
Manganese, Iron, and Chloride are widespread in local groundwater. They are mainly a staining and taste problem, but high manganese also carries a health advisory for infants.
What to test for in Hancock County
- 1Nitrate5% of 176 local samples were above the limit.
- 2Coliform bacteriaRecommended for every private well, every year.
- 3RadonMedian local reading is 570 pCi/L.
- 4ChlorideDetected in 100% of local samples.
- 5FluorideDetected in 93% of local samples.
- 6ManganeseDetected in 93% of local samples.
- 7IronDetected in 76% of local samples.
- 8Volatile organic compounds (VOCs)62 leaking underground storage tank sites on record locally.
Test your Hancock County well for nitrate, coliform bacteria and radon
Certified lab analysis of your own tap water, bottles and prepaid return shipping included. The Essential well panel covers arsenic, uranium, nitrate, lead, copper, manganese, iron, sodium and bacteria; radon and PFAS are add-ons.
Order the Tap Score well water test kit, from $209Already tested? Upload the report
Just want bacteria checked first? Tap Score coliform and E. coli test, $99. Coliform and E. coli are the tests every well needs every year.
Want a quick look before paying for a lab? Home well water test strips on Amazon check hardness, iron, pH and nitrate in minutes. They are a screen, not a result: arsenic, bacteria, uranium and PFAS need a certified lab.
Affiliate links: the merchant pays us a commission and the price is the same for you. It does not change what the data above says. As an Amazon Associate we earn from qualifying purchases.
Where to get a well tested in Indiana: certified labs, state programs and prices.
Already have results back? Get your lab report read against the Hancock County numbers, $29. Every line explained, ranked by what matters, with the fix for each.
The rock under Hancock County
Silurian-Devonian aquifers
Carbonate-rock. Limestone and dolomite move water through cracks and solution channels, sometimes very fast. Bacteria and nitrate can travel from the surface to a well in days, so annual bacteria testing matters more here than most places; hardness is a given.
Classification from the USGS Principal Aquifers of the United States (national map, 2003 edition, GIS release 2015), read at the county centroid. A single well can sit in a different unit, especially near a boundary.
Official help in Indiana
Two places to start that are not selling anything: the state program that answers private well questions, and its list of labs certified to run drinking water tests. A certified lab is the difference between a result you can act on and a number.
- Well Water Quality and Testing, Indiana Department of Health
- Laboratories, IDEM
Contamination sources on record in Hancock County
IDEM records 62 leaking underground storage tank sites in Hancock County, among 77 regulated sites in total. Groundwater does not follow property lines, so a well within a few hundred feet of one of these is worth testing for what that site could release.
- 62
- leaking underground storage tank sitesGasoline and heating oil that leaked from tanks move through groundwater as benzene, MTBE and other volatile organic compounds.
- 15
- other remediation projects
Treatment that fits the local profile
Nitrate
Point-of-use reverse osmosis; Anion exchange; Distillation
Manganese
Oxidizing filter (greensand, birm) whole-house; Water softener (low levels); Point-of-use reverse osmosis
Iron
Oxidizing filter whole-house; Water softener (low levels); Aeration plus filtration
Systems we would look at first
Some links below are affiliate links. If you buy through one, the merchant pays us a commission at no extra cost to you. It does not change which products we list or what the data says.
For nitrate
Under-sink reverse osmosis system
under-sink or countertop, about $300
Look for NSF/ANSI 58 certification listing the contaminant you need removed.
For nitrate
Aquasana SmartFlow reverse osmosis
under-sink or countertop, about $225
Certified to NSF/ANSI 58 and 53 to reduce arsenic (96%, pentavalent), fluoride (90%), lead (99%), nitrate, nitrite and PFOA/PFOS at the kitchen tap, with a remineralizer.
For manganese
Iron and manganese oxidizing filter
whole-house, at the point of entry, about $1,800
Air-injection or greensand media; fixes staining at the source.
Free, no obligation
Get on the list for a free in-home water test in Hancock County
No water treatment company serves Hancock County through Well Water Nerd yet. We are signing licensed companies on county by county: they test at your tap for free, walk you through the numbers, and quote treatment only if something needs fixing. Leave your details and you are first in line. Nothing is shared until a company joins for Hancock County, and you get an email naming it first.
Common questions
How often should I test a private well in Hancock County?
Test for bacteria and nitrate every year. Test once for arsenic, uranium, radon, fluoride, manganese and PFAS, then again every three to five years or after any change in taste, color, or plumbing.
Counties near Hancock County
Closest first. Groundwater does not stop at a line on a map, so the next county over is a fair second opinion.
Want the numbers themselves? Download the Indiana dataset as CSV, every county and town, with the sources named.
Sources
- USGS Water Quality Portal: 537 samples in Hancock County. Data from the Water Quality Portal, a service of USGS, EPA and USDA; groundwater samples collected by USGS and cooperators. Retrieved September 3, 2026.
- USGS national arsenic model (Ayotte 2017): estimated share of 42,642 people on private wells in Hancock County above 10 ug/L of arsenic, from geology, well depth and land use. County estimates of domestic well users with arsenic above 10 ug/L from the USGS national logistic regression model (Ayotte, Medalie and Qi, 2017), with private well population from the USGS 2015 county water-use compilation (Dieter and others, 2018). Retrieved September 15, 2026.
- IDEM regulated sites: 77 regulated sites located in Hancock County. Leaking underground storage tank sites and state cleanup sites from the Indiana Department of Environmental Management. Retrieved September 16, 2026.
Non-detects count as samples and are treated as zero when computing medians. Exactly at the limit counts as not above it. A sample belongs to the town containing the well's reported coordinates.