Well water in Irwin County, Georgia
1in8
Testing recommended
tested well samples in Irwin County exceeded the EPA limit for nitrate (10 mg/L), based on public data from USGS Water Quality Portal.
185 test results across 13 contaminants from at least 11 wells, 1943 to 2024; nitrate has the most at 42. Data refreshed September 15, 2026.
Compiled by Nick at Well Water Nerd from public records. How these pages are built
An estimated 6,138 people in Irwin County get their drinking water from a private well, per USGS 2015 county water use. That is about 66% of residents.
Separately, the USGS national arsenic model estimates that 5% of the 6,138 people on private wells in Irwin County draw water above 10 ug/L (the model's range is 3% to 8%), from geology and well depth rather than local tests.
What individual samples found
Each row summarizes every public sample for that contaminant inside Irwin County. Above limit means above the EPA maximum contaminant level; where EPA has no enforceable limit, the row shows a health guideline or nuisance level instead.
| Contaminant | Above limit | Samples | Detected | Median | Highest | Limit |
|---|---|---|---|---|---|---|
| Nitrate 1943 to 2024 | 42 | 86% | 1.66 | 29.9 | 10 mg/L EPA limit | |
| Fluoride 1943 to 2024 | 20 | 65% | 0.05 | 0.3 | 4 mg/L EPA limit | |
| Uranium 1994 to 2024 | 12 | 50% | 0.004 | 0.248 | 30 ug/L EPA limit | |
| Chloride 1943 to 2024 | no limit | 24 | 96% | 2.77 | 8.66 | 250 mg/L nuisance level |
| Sodium 1943 to 2024 | no limit | 21 | 100% | 2.2 | 5.6 | 20 mg/L health guideline |
| Manganese 1994 to 2024 | no limit | 15 | 100% | 7 | 92 | 300 ug/L health guideline |
| Iron 1994 to 2024 | no limit | 15 | 80% | 14 | 547 | 300 ug/L nuisance level |
Sampled fewer than 10 times, too few to summarize: Lead (9), Copper (9), Arsenic (9), Radium (226 + 228) (3), E. coli (2), Radon (4).
Over time
Share of samples above the limit by period. A cell needs ten samples to show; a comparison needs twenty in each period. Later periods sample fewer wells, and often the ones already known to have a problem.
| Contaminant | before 2000 | 2000s | 2010s | 2020s |
|---|---|---|---|---|
| Nitrate | 13%24 samples | 10%10 samples | n/a | n/a |
Closer than the county
See the sampled wells near your address
The same records, drawn around one point: which wells within a few miles were sampled and what they found, how deep the wells next to you were drilled, and any leaking tank or cleanup site within a mile.
Check my addressWhat this means
The contaminants most often above their limit here are nitrate (12% of 42 samples). A well next door can differ sharply from yours because bedrock fractures, well depth and plumbing all matter, so these rates describe the area, not your tap.
Chloride, Manganese, and Iron are widespread in local groundwater. They are mainly a staining and taste problem, but high manganese also carries a health advisory for infants.
What to test for in Irwin County
- 1Nitrate12% of 42 local samples were above the limit.
- 2Coliform bacteriaRecommended for every private well, every year.
- 3RadonMedian local reading is 950 pCi/L.
- 4ManganeseDetected in 100% of local samples.
- 5ChlorideDetected in 96% of local samples.
- 6IronDetected in 80% of local samples.
- 7FluorideDetected in 65% of local samples.
Test your Irwin County well for nitrate, coliform bacteria and radon
Certified lab analysis of your own tap water, bottles and prepaid return shipping included. The Essential well panel covers arsenic, uranium, nitrate, lead, copper, manganese, iron, sodium and bacteria; radon and PFAS are add-ons.
Order the Tap Score well water test kit, from $209Already tested? Upload the report
Just want bacteria checked first? Tap Score coliform and E. coli test, $99. Coliform and E. coli are the tests every well needs every year.
Want a quick look before paying for a lab? Home well water test strips on Amazon check hardness, iron, pH and nitrate in minutes. They are a screen, not a result: arsenic, bacteria, uranium and PFAS need a certified lab.
Affiliate links: the merchant pays us a commission and the price is the same for you. It does not change what the data above says. As an Amazon Associate we earn from qualifying purchases.
Where to get a well tested in Georgia: certified labs, state programs and prices.
Already have results back? Get your lab report read against the Irwin County numbers, $29. Every line explained, ranked by what matters, with the fix for each.
The rock under Irwin County
Surficial aquifer system
Unconsolidated sand and gravel. Wells in sand and gravel are usually shallow and productive, and they recharge quickly from the surface. That makes them the most exposed to nitrate, bacteria and anything spilled nearby, and the least likely to carry arsenic or radon from the rock.
Classification from the USGS Principal Aquifers of the United States (national map, 2003 edition, GIS release 2015), read at the county centroid. A single well can sit in a different unit, especially near a boundary.
Official help in Georgia
Two places to start that are not selling anything: the state program that answers private well questions, and its list of labs certified to run drinking water tests. A certified lab is the difference between a result you can act on and a number.
- Well Water, Georgia Department of Public Health
- Drinking Water (certified laboratory lists), Georgia EPD
Treatment that fits the local profile
Nitrate
Point-of-use reverse osmosis; Anion exchange; Distillation
Manganese
Oxidizing filter (greensand, birm) whole-house; Water softener (low levels); Point-of-use reverse osmosis
Iron
Oxidizing filter whole-house; Water softener (low levels); Aeration plus filtration
Systems we would look at first
Some links below are affiliate links. If you buy through one, the merchant pays us a commission at no extra cost to you. It does not change which products we list or what the data says.
For nitrate
Under-sink reverse osmosis system
under-sink or countertop, about $300
Look for NSF/ANSI 58 certification listing the contaminant you need removed.
For nitrate
Aquasana SmartFlow reverse osmosis
under-sink or countertop, about $225
Certified to NSF/ANSI 58 and 53 to reduce arsenic (96%, pentavalent), fluoride (90%), lead (99%), nitrate, nitrite and PFOA/PFOS at the kitchen tap, with a remineralizer.
For manganese
Iron and manganese oxidizing filter
whole-house, at the point of entry, about $1,800
Air-injection or greensand media; fixes staining at the source.
Free, no obligation
Get on the list for a free in-home water test in Irwin County
No water treatment company serves Irwin County through Well Water Nerd yet. We are signing licensed companies on county by county: they test at your tap for free, walk you through the numbers, and quote treatment only if something needs fixing. Leave your details and you are first in line. Nothing is shared until a company joins for Irwin County, and you get an email naming it first.
Common questions
How often should I test a private well in Irwin County?
Test for bacteria and nitrate every year. Test once for arsenic, uranium, radon, fluoride, manganese and PFAS, then again every three to five years or after any change in taste, color, or plumbing.
Counties near Irwin County
Closest first. Groundwater does not stop at a line on a map, so the next county over is a fair second opinion.
Want the numbers themselves? Download the Georgia dataset as CSV, every county and town, with the sources named.
Sources
- USGS Water Quality Portal: 185 samples in Irwin County. Data from the Water Quality Portal, a service of USGS, EPA and USDA; groundwater samples collected by USGS and cooperators. Retrieved September 3, 2026.
- USGS national arsenic model (Ayotte 2017): estimated share of 6,138 people on private wells in Irwin County above 10 ug/L of arsenic, from geology, well depth and land use. County estimates of domestic well users with arsenic above 10 ug/L from the USGS national logistic regression model (Ayotte, Medalie and Qi, 2017), with private well population from the USGS 2015 county water-use compilation (Dieter and others, 2018). Retrieved September 15, 2026.
Non-detects count as samples and are treated as zero when computing medians. Exactly at the limit counts as not above it. A sample belongs to the town containing the well's reported coordinates.