Well Water Nerd

Well water in Gordon County, Georgia

No public well test results have been compiled for Gordon County yet. The USGS national arsenic model estimates that <1% of the 7,216 people on private wells there draw water with arsenic above 10 ug/L, the EPA limit, based on geology, well depth and land use rather than local tests.

The strongest signal is nitrate: 8% of 12 local samples were above the limit, too few samples to carry the headline but first on the test list below.

52 test results across 9 contaminants from at least 12 wells, 1947 to 1971; nitrate has the most at 12. Data refreshed September 15, 2026.

Compiled by Nick at Well Water Nerd from public records. How these pages are built

An estimated 7,216 people in Gordon County get their drinking water from a private well, per USGS 2015 county water use. That is about 13% of residents.

Separately, the USGS national arsenic model estimates that <1% of the 7,216 people on private wells in Gordon County draw water above 10 ug/L (the model's range is <1% to 1%), from geology and well depth rather than local tests.

What individual samples found

Each row summarizes every public sample for that contaminant inside Gordon County. Above limit means above the EPA maximum contaminant level; where EPA has no enforceable limit, the row shows a health guideline or nuisance level instead.

ContaminantAbove limitSamplesDetectedMedianHighestLimit
Nitrate
1947 to 1971
12100%0.851110 mg/L
EPA limit
Fluoride
1947 to 1971
12100%0.250.64 mg/L
EPA limit
Chloride
1947 to 1971
no limit12100%4.522250 mg/L
nuisance level
Sodium
1958 to 1971
no limit11100%2.81420 mg/L
health guideline

Sampled fewer than 10 times, too few to summarize: Copper (1), Arsenic (1), Lead (1), Iron (1), Manganese (1).

Closer than the county

See the sampled wells near your address

The same records, drawn around one point: which wells within a few miles were sampled and what they found, how deep the wells next to you were drilled, and any leaking tank or cleanup site within a mile.

Check my address

What this means

The contaminants most often above their limit here are nitrate (8% of 12 samples). A well next door can differ sharply from yours because bedrock fractures, well depth and plumbing all matter, so these rates describe the area, not your tap.

Chloride, Iron, and Manganese are widespread in local groundwater. They are mainly a staining and taste problem, but high manganese also carries a health advisory for infants.

What to test for in Gordon County

  1. 1
    Nitrate
    8% of 12 local samples were above the limit.
  2. 2
    Coliform bacteria
    Recommended for every private well, every year.
  3. 3
    Fluoride
    Detected in 100% of local samples.
  4. 4
    Copper
    Detected in 100% of local samples.
  5. 5
    Chloride
    Detected in 100% of local samples.
  6. 6
    Iron
    Detected in 100% of local samples.
  7. 7
    Manganese
    Detected in 100% of local samples.

Test your Gordon County well for nitrate, coliform bacteria and fluoride

Certified lab analysis of your own tap water, bottles and prepaid return shipping included. The Essential well panel covers arsenic, uranium, nitrate, lead, copper, manganese, iron, sodium and bacteria; radon and PFAS are add-ons.

Order the Tap Score well water test kit, from $209Already tested? Upload the report

Just want bacteria checked first? Tap Score coliform and E. coli test, $99. Coliform and E. coli are the tests every well needs every year.

Want a quick look before paying for a lab? Home well water test strips on Amazon check hardness, iron, pH and nitrate in minutes. They are a screen, not a result: arsenic, bacteria, uranium and PFAS need a certified lab.

Affiliate links: the merchant pays us a commission and the price is the same for you. It does not change what the data above says. As an Amazon Associate we earn from qualifying purchases.

Where to get a well tested in Georgia: certified labs, state programs and prices.

Already have results back? Get your lab report read against the Gordon County numbers, $29. Every line explained, ranked by what matters, with the fix for each.

The rock under Gordon County

Valley and Ridge aquifers

Sandstone and carbonate-rock. Layered sandstone and limestone means a well may draw from either. Hardness and iron are routine, and the limestone layers can carry bacteria and nitrate from the surface quickly, so test for both yearly.

Classification from the USGS Principal Aquifers of the United States (national map, 2003 edition, GIS release 2015), read at the county centroid. A single well can sit in a different unit, especially near a boundary.

Official help in Georgia

Two places to start that are not selling anything: the state program that answers private well questions, and its list of labs certified to run drinking water tests. A certified lab is the difference between a result you can act on and a number.

Treatment that fits the local profile

Nitrate

Point-of-use reverse osmosis; Anion exchange; Distillation

Systems we would look at first

Some links below are affiliate links. If you buy through one, the merchant pays us a commission at no extra cost to you. It does not change which products we list or what the data says.

For nitrate

Under-sink reverse osmosis system

under-sink or countertop, about $300

Look for NSF/ANSI 58 certification listing the contaminant you need removed.

For nitrate

Aquasana SmartFlow reverse osmosis

under-sink or countertop, about $225

Certified to NSF/ANSI 58 and 53 to reduce arsenic (96%, pentavalent), fluoride (90%), lead (99%), nitrate, nitrite and PFOA/PFOS at the kitchen tap, with a remineralizer.

Free, no obligation

Get on the list for a free in-home water test in Gordon County

No water treatment company serves Gordon County through Well Water Nerd yet. We are signing licensed companies on county by county: they test at your tap for free, walk you through the numbers, and quote treatment only if something needs fixing. Leave your details and you are first in line. Nothing is shared until a company joins for Gordon County, and you get an email naming it first.

What are you worried about?

The test is free and there is no obligation. No company is named yet; your details stay with us until one joins for your area, and we log the time and address of this request.

Common questions

How often should I test a private well in Gordon County?

Test for bacteria and nitrate every year. Test once for arsenic, uranium, radon, fluoride, manganese and PFAS, then again every three to five years or after any change in taste, color, or plumbing.

Counties near Gordon County

Closest first. Groundwater does not stop at a line on a map, so the next county over is a fair second opinion.

Want the numbers themselves? Download the Georgia dataset as CSV, every county and town, with the sources named.

Sources

  • USGS Water Quality Portal: 52 samples in Gordon County. Data from the Water Quality Portal, a service of USGS, EPA and USDA; groundwater samples collected by USGS and cooperators. Retrieved September 3, 2026.
  • USGS national arsenic model (Ayotte 2017): estimated share of 7,216 people on private wells in Gordon County above 10 ug/L of arsenic, from geology, well depth and land use. County estimates of domestic well users with arsenic above 10 ug/L from the USGS national logistic regression model (Ayotte, Medalie and Qi, 2017), with private well population from the USGS 2015 county water-use compilation (Dieter and others, 2018). Retrieved September 15, 2026.

Non-detects count as samples and are treated as zero when computing medians. Exactly at the limit counts as not above it. A sample belongs to the town containing the well's reported coordinates.